Frigidaire CGLES389FB3 Use & Care Manual page 10

Models with Ceramic Glass Cooktop (continued)
Hot Surface indicator Lights
After using any of the radiant ebment positions the cooktop wifl become very hot. After turning
any of these ebments OFF, the cooktop wifl remain HOT for some time. The "Hot Surface"
indicator fight wifl glow whenever any of the ebment positions becomes HOT. The Hot Surface
indicator light wifl remain ON whib hot and turn OFF once the cooktop has coobd sufficbntly.
ESEC Error indicator Message (Er)
An error message wifl be displayed (flashing "E¢') at power up (or after a power failure) if ANY
of the surface control knobs were left in the ON positions (See Fig.l). If a power failure should
occur, be sure to set all of the surface control knobs to the OFF position. This will reset the
surface controls.
Once the su trace controls have been set to the OFF positions, the surface controls should return
to normal operation. If the su rface controls do not function and the"Er" message remains in any
display after following these procedures, contact an authorized servicer for assistance.
ESEC Lockout Feature ( - - )
The ESEC feature will not operate during a Self-Cban cycle. Whenever the ESEC Lockout
feature is active, " - - " will appear in any display window (See Fig. 2).
Fig. 1
Fig. 2
Operating Single Radiant Surface E_ements (Mode_s with Ceramic G_ass Cooktop On_y)
The cooktop has single radiant surface elements at location as shown on Figs, 4 to 7,
To Operate the Single Surface Emements:
1, Place correctly sized cookware on the radiant surface element,
2.
Push in and turn the surface control knob in either direction to the desired setting (Fig.
3). Turn the knob to adjust the setting if desired. Start most cooking operations on a Sirn
higher setting and then turn to a lower setting to finish cooking. Each surface element 2
provides a constant amount of heat at each setting. A glowing red su trace heating area
extending beyond the bottom edge of the cookware indicates the cookware is too
smaJl for the surface heating area.
3.
When cooking has completed, turn the surface control knob to OFF before removing
the cookware, Note: The Surface indicator light will come on when the control knob
wiii be turn on and wiii continue to glow until the glass cooktop has cooled down to a
moderate level, The light may remain on even though the controls are turned OFF,
Note: See page 9, Fig. 1 for recommended control settings.
OFF
4
reed
Fig, 3
6
Fig. 4- Model B
Left & Right Rear Ele-
ments and Left front
element
Fig. 5 -Model C
Left & Right Rear Ele-
ments and Left front
element
Fig. 6 -Model D
Left & Right Rear Ele-
ments and Left front
element.
o o
oo
Fig. 7 - Model E
Left Rear Element & Left
Front Area of the Bridge
Element can also be used
as a singe element (see
page 12).
10