Advertisement
Setting Warming Drawer Controls
Removing
& Replacing
the Warming
Drawer
Pull up with finger
Left Glide
Push clown with finger
Fig. 1
m
Be,_ring Glide
!
Fig. 2
Electrical Shock Hazard can occur and result in
serious injury or death, Disconnect appliance from electric power
before cleaning and servicing theWarming
Drawer,
To Remove
and Replace
the Warming
Drawer
(some models)
To Remove the Warming
Drawer:
1.
_
Turn power off before removing the Warming Drawer.
2.
Open the drawer to the fully opened position.
3.
Locate glide lever on each side of drawer, pull up on the left glide lever and
push clown on the right glide lever (See Fig.l).
4.
Pull the drawer away from the range.
To Replace the Warming
Drawer:
1.
Pull the bearing glides to the front of the chassis glide (See Fig. 2).
2.
Align the glide on each side of the drawer with the glide slots on the range.
3.
Push the drawer into the range until levers "click" (approximately 2"). Pull
the drawer open again to seat bearing glides into position. If you do not
hear the levers "click"
or the bearing glides
do not feel seated
remove the drawer and repeat steps I thru 3, This will minimize
possible damage to the bearing glides.
NOTE: The Warming Drawer will NOT operate while in the Self-Clean and !!Oven
Lockout" modes,
Advertisement
