Advertisement
More about
your Advanced
Water
Filter
The PureSource
IJItra
TM
ice and water
filter system is tested and certified by NSF
International,
to NSF/ANSI Standards 42
and 53 for the reduction of claims specified
on the performance data sheet.
Do not use with water that is microbiologica!ly
unsafe
or of unknown quality without adequate disinfection
before or after the system. Systems certified for cyst
reduction may be used on disinfected waters that may
contain filterable cysts.
Test & certification
results,"
o Rated Capacity - 200 gallons/757 liters for
PureSource
Ultra
TM
ice and water filter
Rated service flow = .50 gallons per minute
Operating Temp.: Min. 33°1:, Max. 100°F
Maximum Rated Pressure - 100 pounds per
square inch
Recommended Minimum Operating Pressure: 30
pounds per square inch
To replace
your PureSource
Ultra
TM
water
filter:
It is not necessary to turn the water supply off to
change the filter. Be ready to wipe up any small amounts
of water released during the filter replacement.
1
Turn Off the ice maker.
2
Remove the filter by pushing on the end/face of
the filter.
3
Slide the old water filter cartridge straight out of
the housing and discard it.
4
Unpackage the new filter cartridge.
Using the
alignment guide, slide it gently into the filter
housing until it stops against the snap=in connector
at the back of the housing.
5
Push firmly
until the cartridge
snaps
into place (you should hear a click as the
cartridge
engages the snap=in connector),
6
Press a drinking glass against the water dispenser
while checking for any leaks at the filter housing.
Any spurts and sputters that occur as the system
purges air out of the dispenser system are normal.
7
8
9
After filling one glass of water, continue flushing
the system for about three
minutes.
Turn On the ice maker.
Press and hold the Filter Status
button on the Ice
& Water Dispenser control panel for three seconds.
When the display changes from "Replace"
to
"Good," the status has been reset.
Advertisement
