Before Setting Oven Controls; Arranging Oven Racks; Oven Vent Location - Frigidaire Gallery Series Owner's Manual

Drop-in/slide-in model
Hide thumbs Also See for Gallery Series:
Table of Contents

Advertisement

Setting
Warm Zone Controls (some models) (continued)
Indicator
Lights
The Surface
indicatorlight
is located
above or below the warm
zone control.
It turns on when the
control
is set, and stays on until the control
is turned
off. The hotsurface
indicatorlight,
located
under the glass cooktop,
will come on when the control
is set and will continue
to glow until the glass
cooktop
has cooled down to moderate
level.
OFF
WARM
& SERVE
ZONE
,_
Warm
To Set the Warm Zone Control
1. To set the control,
push in and turn the knob. The temperatures
are approximate,
and are designated
by HI,
M ED and LO. However, the control can be set at any position
between
HI and LO for different
levels of heating.
2. When
done, turn the control to OFE The warm zone will remain warm
until the hotsurfaceindicatorlight
goes off.
Hot Surface Indicator Light
Temperature
Selection
Refer to the chart for recommended
heating levels. If a particular
food is not listed, start with the medium
level, and adjust as needed. Most food
can be kept at serving temperatures
by using the medium
level.
Warm Zone Recommended
Food Settings
Chart
Food Item
Food Item
Heating
Level
Breads/Pastries
LO
Casseroles
LO
Dinner Plate with Food
LO
Eggs
LO
Gravies
LO
Meats
MED
Heating
Level
Sauces
MED
Soups (cream)
MED
Stews
MED
Vegetables
MED
Fried Foods
HI
Hot Beverages
HI
Soups (liquid)
HI
Before Setting
Oven Controls
Oven
Vent
Location
The oven is vented
at the rear of the cooktop.
When
the oven is on, warm air is released
through
the vents. This venting
is necessary for proper air circulation
in the oven and good
baking
results.
DO NOT block the vents.
Doing
so may cause cooking
failures,
fire or
damage
to the appliance
Arranging
Oven
Racks
AL WA YS ARRANGE
OVEN RACKS WHEN THE OVEN IS COOL (PRIOR TO OPERATING THE
OVEN). Always
use oven mitts when
using the oven.
To remove an oven rack, pull the rack forward until it stops. Lift up front of rack and
slide out.
To replace an oven rack, Fit the rack onto the guides on the oven walls. Tilt the front
of the rack upward and slide the rack back into place.
Setting
Oven Controls
For oven settings,
refer to the time or the electronic
oven control
section.
General 9 information

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Gallery professional series

Table of Contents