Frigidaire FGFL87GSH Use & Care Manual page 10

Removing&Replacing the Warming Drawer
Left Glide
Push down with finger
Fig. 1
Fig. 2
Pull up with finger
Electrical Shock Hazard can occur and result in
serious injury or death. Disconnect appliance from electric power
before cleaning and servicing the Warming Drawer.
To Remove and Replace the Warming Drawer (some models)
To Remove the Warming Drawer:
1. _ Turn poweroff before removing theWarming Drawer.
2. Open the drawer to the fully opened position.
3. Locate glide lever on each side of drawer, pull up on the left glide lever and
push down on the right glide lever (See Fig.l).
4. Pull the drawer away from the range.
To
1.
2.
3.
Replace the Warming Drawer:
Pull the bearing glides to the front of the chassis glide (See Fig. 2).
Align the glide on each side of the drawer with the glide slots on the range.
Push the drawer into the range until levers "click" (approximately 2"). Pull
the drawer open again to seat bearing glides into position. If you do not
hear the levers "click" or the bearing glides do not feel seated
remove the drawer and repeat steps 1 thru 3. This will minimize
possible damage to the bearing glides.
NOTE The Warm ng Drawerw I NOT operate wh e n the Self, Clean and ',Oven
Lockout', modes.
10