Removable Outer Door Glass Panel (Some Models); To Remove And Replace Storage Drawer - Frigidaire CGLEF384DS2 Use & Care Manual

RemovabMe Outer Door GMass PaneM(some models}
Applicable only to models with an external glass panel not held with a frame. This design allows you to clean the inside face of the
exterior door panel as well as the hidden face of the door inner glass.There are two different kinds of glass panel; one with a lower
metal trim fixed on the underside of the glass panel and the other one with a lower metal support rail.
To remove the external door glass panel:
1. Pull the door off the range as per instructions under "To Remove and Replace Oven Door" in "Cleaning the Appliance"
section and lay the door flat.
2. Using a screwdriver, remove the screws fastening the glass lower metal trim or the glass assembly.
3. Grab both sides of the glass panel and slowly pull it out of the door upper moulding. Lay the glass flat.
Handle the glass panel with care. When dropped on a corner the glass panel may shatter in multiple fragments and
you could get hurt.
DO NOT remove the lower metal trim, which is fixed on the underside of tile glass panel.
To replace the external door panel:
1. Grab the sides of the glass panel and carefully insert tile glass into tile door top moulding.
2. Replace the glass lower trim or the glass assembly using the locking screws.
3. Replace the door onto the range as per "To Remove and Reptace Oven Door" in "Cleaning the Appliance" section.
To remove the Drawer:
Push down the lelt latch
and pull up the right latches.
Pull drawer out
of range.
To Remove and Replace Storage Drawer
To Remove/Replace the Storage Drawer with Extendable Glides (some models}
Use the storage drawer for storing cooking utensils. Tile drawer can be removed to facilitate
cleaning under the range. Use care when handling the drawer.
To Remove the Drawer:
1. Pull out the empty drawer until it stops.
2. Push down the left glide latch and pull up tile right glide latch.
3. Pull drawer out of tile range.
To Replace the Drawer:
1. Slide the drawer rails over the glides.
2. Push the drawer back into the range.
ROLLER
/
/
RAILS
l To
Remove/Replace the Storage Drawer with Rotters (some models)
To Remove the Drawer:
1. Pull the empty drawer out to the roller guide stop.
2. Tilt tile drawer up and pull it out over tile rollers.
To Replace the Drawer:
1. Insert the rear end of the drawer into the opening.
2. Fit tile drawer end rollers onto the guide rails.
3. Push the drawer in until it stops, then lift to allow tile rollers to clear tile roller guide stop,
and
push
in.
27