Troubleshooting - Craftsman 917.272441 Owner's Manual

20.0 hp electric start 42" mower automatic lawn tractor
Table of Contents

Advertisement

TROUBLESHOOTING
CHART
PROBLEM
CAUSE
CORRECTION
Will not start
Hard to start
Enginewill not
turn over
Engine clicks but
_vill not start
Loss of power
1. Out of fuel.
2. Engine not "CHOKED"
properly.
3. Engine
flooded.
1. Fill fuel tank.
2. See =TO START ENGINE"
in Operation
section.
3. Wait several minutes before
attempting
to start.
Replace spark plug.
Clean/replace
air filter.
Replace fuel filter.
Drain fuel tank and carbure-
tor, refill tank with fresh
gasoline
and replace fuel
filter.
8. Check all widng.
9. See "To Adjust Carburetor"
in Service Adjustments
section.
10. Contact a Sears or other
qualified
service
center.
4.
Bad spark plug.
4.
5. Dirty airfiltec
5.
6. Dirty fuel filte_
6.
7. Waterinfuel.
7.
8. Loose or damaged
wiring.
9. Carburetor
out of adjustment.
10. Engine valves out of
adjustment.
1. Dirty air filter.
2. Bad spark plug.
3. Weak or dead battery.
4. Dirty fuel filter.
5. Stale or dirty fuel.
,
7.
.
,
2.
.
4.
5.
6.
7.
.
.
,
2.
3.
4.
,
2.
.
2.
.
4.
5.
Loose or damaged
wiring.
6.
Carburetor
out of adjustment.
7.
Engine valves out of
8.
adjustment.
Brake pedal not depressed.
1.
Attachment
clutch is
2.
engaged.
Weak or dead battery.
3.
Blown fuse.
4.
Corroded
battery terminals.
5.
Loose or damaged
wiring.
6.
Faulty ignition
switch.
7.
Faulty solenoid
or starter.
8.
Faulty operator
presence
9.
switch(es).
Weak or dead battery.
1.
Corroded
battery terminals.
2.
Loose or damaged
wiring.
3.
Faulty solenoid or starter.
4.
Cutting too much grass/too
1.
fast.
Throttle
in "CHOKE"
2.
position.
Clean/replace
air filter.
Replace spark plug.
Recharge or replace battery.
Replace fuel filter.
Drain fuel tank and refill with
fresh gasoline.
Check all wiring.
See "To Adjust Carburetor"
ir
Service Adjustments
section.
Contact a Sears or other
qualified
service
center.
Depress brake pedal.
Disengage
attachment
clutch.
Recharge or replace battery.
Replace fuse.
Clean battery ternlinals.
Check all wiring.
Check/replace
ignition
switch.
Check/replace
solenoid or
starter.
Contact a Sears or other
qualified service center.
Recharge or replace battery.
Clean battery terminals.
Check all wiring.
Check/replace
solenoid or
starter.
Set in "Higher Cut" position/
reduce
speed.
Adjust throttle control.
3O

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents