Craftsman 172.11625 Owner's Manual page 13

ATTACHING DUST BAG ASSEMBLY cont. (See Fig. 4)
2. Insert dust bag adapter into dust exhaust hole (see Fig. 4).
3. Push in adapter until the raised edges on the top and bottom of the adapter
snap into the grooves in the dust exhaust hole.
4. Your sander is now ready to use.
NOTE: For more efficient operation, we recommend that you empty the dust
bag when it is no more than half full. This will allow the air to flow through the
bag better. ALWAYS empty and clean the dust bag thoroughly when you've
finished sanding and before you store the sander.
Fig 4_
......
TO REMOVE AND EMPTY DUST BAG (See Fig. 5)
1. Unplug the sander.
I Z_ WARNING:
Failure to unplug the sander could result in accidental
starting causing possible serious personal injury.
2. Remove dust bag assembly from sander by firmly holding the adapter
and pulling straight out.
3. Remove dust bag from adapter (see Fig. 5).
4. Shake dust bag to empty.
5. Place dust bag back onto the adapter.
6. Attach dust bag assembly back onto sander,
I
13