Advertisement
ASSEMBLY INSTRUCTIONS
IA WARNING
I
To avoid injury, do not connect this miter saw to the
power source until it is completely
assembled
and
adjusted and you have read and understood
this
Operator's
Manual.
ASSEMBLE
STAND (FIG. A)
1. Unpack all parts and group by type and size. Refer to
the parts list on page 30 for correct quantities.
2. Attach one long upper support (4) to top of leg (1)
using one carriage bolt (2) and nut (5).
NOTE: Do not tighten bolts until stand is properly
aligned (see step #8).
3. Attach other end of long upper support to the top of
another leg using one carriage bolt and one nut.
4. Attach one long bottom support (3) to the center of
each leg using carriage bolt and nut. This completes
the front frame section.
5. Assemble the rear frame section in exactly the same
manner.
6. Join the front and rear frame assemblies using
two short upper supports (6) and two short bottom
supports (8), carriage bolts and nuts.
7. Place all four foot pads (7) onto each leg.
8. Place the stand on a level surface and adjust it so all
legs are contacting the floor and are at similar angles
to the floor. Tighten all bolts.
NOTE: Stand should not rock after all bolts are
tightened.
ASSEMBLE
MITER SAW TO STAND
1. Carefully place the miter saw on top of stand.
2. Line up the four mounting holes in the saw base to
the stand.
3. Fasten the saw to the stand using the four mounting
screws (9), four washers (10) and four nuts (11).
NOTE: Place a washer on each bolt before inserting
it into the saw base and through the support, then
thread the nut onto the bolt. (see Fig. A)
4. Tighten all four nuts.
NOTE: DO NOT OVER TIGHTEN THE LOCK NUTS
HOLDING SAW TO THE STAND. THiS COULD
DAMAGE THE SAW BASE.
Fig. A
Saw Base (saw not
shown for clarity of v_w)_
_'-7
Advertisement
