Advertisement
Available languages
Available languages
WARNING:
TO AVOID
SERIOUS
INJURY,
BEFORE
PERFORMING
ANY SER-
VICE OR ADJUSTMENTS:
1.
Depress
clutch/brake
pedal fully and set parking
brake.
2.
Place gearshift
lever in neutral
(N) position.
3.
Place attachment
clutch
in "DISENGAGED"
position.
4.
Turn ignition
key to "STOP"
and remove
key.
5.
Make sure the blades
and all moving
parts have completely
stopped.
6.
Disconnect
spark
plug wire from spark plug and place wire where
it cannot
come in contact
with plug.
TRACTOR
TO REMOVE
MOWER
1.
Place
attachment
clutch
in "DISEN-
GAGED"
position.
2.
Lower
attachment
lift lever to its lowest
position.
3.
Roll belt off engine
pulley (M).
4.
Remove
retainer
spring
(K), slide collar
(L) off and push housing
guide (P) out
of bracket.
5.
Remove
clutch
cable spring
(Q) from
idler arm (R).
6.
Disconnect
front link (E) from mower
- remove
retainer
spring
and washer.
7.
Go to either side of mower and discon-
nect mower suspension
arm (A) from
chassis
pin (B) and rear lift link (C)
from rear mower
bracket
(D) - remove
retainer
springs
and washers.
8.
Go to other side of mower
and discon-
nect the suspension
arm and rear lift
link.
_,
CAUTION:
After rear lift links are dis-
connected,
the attachment
lift lever will be
spring
loaded.
Have a tight grip on lift lever
when changing
position
of the lever.
9.
Slide mower
out from under
right side
of tractor.
IMPORTANT:
If an attachment
other than
the mower
is to be mounted
on the tractor,
remove
the front link (E) and rear lift liks
(C) from tractor
and hook the clutch
spring
(Q) into the cable
guide on front edge of
lower dash.
TO INSTALL
MOWER
Be sure tractor
is on level surface
and
engage
parking
brake.
1.
Lower attachment
lift lever to it's lowest
position.
CAUTION:
Lift lever is spring
loaded.
Have a tight grip on lift lever, lower it
slowly
and engage
in lowest
position.
©
20
03042
Advertisement
