Advertisement
Blade Diameter
Blade Arbor
No Load Speed
Charger Rating
Charger Rate
Motor
Net Weight
Blade Type
8-1/4 in.
5/8 in.
2000 RPM
120 Volts, 60 Hz-AC Only
1 Hour
18 Volt DC
35 Ibs.
Carbide Tipped (Thin Kerr)
Cutting Capacity with Miter at 0°/Bevel 0°:
5-1/2 in. W x 2-1/16 in. T
Maximum Cutting Capacity with Miter at 45°/Bevel 0°:
3-3/4 in. W x 2-1/16 in. T
Maximum Cutting Capacity with Miter at 0°/Bevel 45°:
5-1/2 in. W x 1-1/2 in. T
Maximum Cutting Capacity with Miter at 45°/Bevel 45°:
3-3/4 in. Wx 1-1/2 in. T
Your Compound Miter Saw has been shipped
completely assembled except for the battery pack,
blade, dust guide, and dust bag.
_i,
WARNING:
If any parts are missing, do not
operate this tool until the missing parts are
replaced. Failure to do so could result in possible
serious personal injury.
•
Remove all loose parts from the carton. Separate
and check with the list of loose parts. See Figure 2.
•
Remove the packing materials from around your
saw.
•
Carefully lift saw from the carton and place it on a
level work surface. Although small, this saw is
heavy. To avoid back injury, get help when
needed.
Do not discard the packing materials until you
have carefully inspected the saw, identified all
loose parts, and satisfactorily operated your new
saw.
•
Your saw has been shipped with the saw arm
locked in the down position. To release saw arm,
push down on top of saw arm and pull out the lock
pin. See Figure 9.
•
Lift the saw arm by the handle. Hand pressure
should remain on the saw arm to prevent sudden
rise upon release of the lock pin.
•
Examine all parts to make sure no breakage or
damage has occurred during shipping.
if any parts are damaged or missing, do not attempt to
turn the switch on until the damaged or missing parts
are obtained and are installed correctly.
8
Advertisement
