Table of Contents
Advertisement
,_
WARNING:
When servicing, use only idenfica}
Craftsman replacement parts. Use of any other part
may create a hazard or cause product damage,
,_
WARNING:
A)ways wear sa_e_ygoggles or safety
glasses with side shields when using compressed air
to ctean tools if the operation is dusty, also wear a
dust mask,
._
WARNING:
To avoid serious persona! in)ury, aiways
remove the battery pack from the tool when cleaning
or performing any maintenance.
GENERAL
MAINTENANCE
Avoid using solvents when cleaning plastic parts° Most
plastics are susceptible to damage from various types of
commercial so}vents and may be damaged by their use.
Use cIean cloths to remove dirt, dust, oil, grease, etc
,_
WARNING:
Do not at any time tot brake fluids,
gasoline, petroleum-based products, penetrating
oils, etc,, come in contact with plastic parts,
Chemicals can damage, weaken or destroy plastic
which may result in serious personal injury-
Only the parts shown on the parts list are intended to be
repaired or replaced by the customer. All other parts
should be replaced at a Sears Service Center.
CHUCK
REMOVAL
See Figures 15 - t7,
The chuck may be removed and replaced by a new one.
[] Lock the switch trigger by placing the direction of
rotation selector in center position,
[] Insert a 5/16 in. or larger hex key into the chuck of the
dfllt and ttghten the chuck )_,vs secuTely.
[] Tap the hex key sharply with a mallet in a olock_wise
direction. This wit1loosen the screw in the chuck for
easy removal.
MALLET
Fig. 15
m Open the chuck jaws and remove the hex key. Using a
screwdriver, remove the chuck screw by turning it in a
clockwise direclion.
NOTE: The chuck screw has left hand threads.
SCREWDRIVER
\.,
16
Advertisement
Table of Contents
