2-In-1 Siphon System; Add Engine Oil; Add Fuel; Attach Project Pro Perfectmix Siphon To Pump - Craftsman 580.752260 Operator's Manual

B,
,
Attach rope guide (A) through handle with plastic knob
(B). Tighten by hand. Route engine recoil rope through
guide.
Align hose wrap (C) to the back side of accessory tray.
Locate notch with "unlock" icon (D) on hose wrap.
Position notch at top with hose wrap in vertical position.
Clips in the back of accessory tray should slide into the
grooves on the inside surface of hose wrap. Slide hose
wrap on back of accessory tray and rotate 1/8 turn until
"locked"icon (E) is in vertical position. Hose wrap is
easily removed from the accessorytray for wrapping and
unwrapping of the high pressure hose. A clip to secure
the hose on the reel makes it easy to wrap the hose
while it is detached from the accessory tray.
/
,
Attach bottle bracket (F) to handle with carriage bolt (G)
and black plastic knob (H). Tighten by hand.
2-1N-1 SIPHOHSYSTEM
The pressure washer is equipped with two detergent
siphoning hoses.
Standard Clear Siphon Tube
Cleartube with filter:
Whenusingtheclearsiphontube,dilute
1part concentrate to 16 parts water
(4 ozof standard concentrate makes
1/2gaflonof mix.)
ProjectPro®PerfectMWMSiphon
Blue tube with blue bottle cap:
Whenusingtheblue PerfectMix
T M
siphon,
usetheconcentrate straightfrom the bottle
(Onequartbottle of PerfectMix
TM
concentrate
makes4.25gaflonsof soapspray.)
Attach Project Pro ®PerfectMix
TM
Siphonto Pump
Attach the hose end of the blue Project Pro®PerfectMix
TM
Siphon (J) to the barbed hose fitting (K) on the pump.
Attach PerfectMix
TM
Detergent Siphon
to Concentrate BottJe
Place Project Pro® PerfectMix
TM
bottle (not included) in the
wire-form bracket on the handle. Removecap from bottle
and insert the Project Pro®PerfectMix
TM
Siphon (M). Screw
the siphon unit to the top of the bottle (N). Usethe clip on
the cap (M) to snap siphon to wire form bracket when siphon
is not in a concentrate bottle.
Add EngineOil
1. Placepressure washer on a flat, level surface.
2. Cleanarea around oil fill and remove yellow oil fill
cap/dipstick.
3. Using oil funnel (optional), slowly pour contents of
provided oil bottle into oil fill opening.
NOTICE
Improper treatment of pressure washer can damage it and
shorten its life.
DONOTattemptto crankor startthe enginebeforeit hasbeen
properlyservicedwith the recommended oil. This mayresult in
an enginefailure.
4. Replace oil fill cap/dipstick and fully tighten.
Add Fuel
Fuel must meet these requirements:
• Clean,fresh, unleaded gasoline.
• A minimum of 87 octane/B7AKI (91 RON). High altitude
use, see High Altitude.