AND ADJUSTMENTS
l llINNll,
.............................................
I
Lll
=l=l=
=l=l=l=l=l=l=,l=
,I
TO LEVEL MOWER HOUSING
Adjust the mower while tractor is parked on level ground or
driveway.
Make sure tires are properly inflated (See
"PRODUCT SPECIFICATIONS" on page 3 of this manual).
If tires are over or underinflated, you will not properlyadjust
your mower_
SIDE-TO-SIDE ADJUSTMENT (See Figs. 2i and 22)
•
Raise mower to its highest position.
•
At the midpoint of both sides of mower, measure height
from bottom edge of mower to ground. Distance"A" on
both sides of mower should be the same or within 1/4"
of each other.
°
If adjustment is necessary, make adjustment on one
side of mower onfy.
°
To raise one side of mower, tighten lift linkadjustment
nut on that side.
°
To lower one side of mower', loosen lift linkadjustment
nut on that side.
NOTE: Each full turn of adjustment nut will change mower
height about 1/8".
•
Recheck measurements after adjusting.
BOTTOM EDGE
BOTTOM EDGE
OF MOWER TO
OF MOWER TO
GROUND
GROUND
GROUND LINE
FIG. 21
FRONT-TO-BACK ADJUSTMENT (See Figs. 23 and 24)
IMPORTANT: DECK MUST BE LEVEL SIDE-TO-SIDE. IF
THE FOLLOWING FRONT-TO-BACK ADJUSTMENT IS
NECESSARY, BE SURETO ADJUST BOTH FRONT LINKS
EQUALLY SO MOWER WILL STAY LEVEL SIDE-TO-
SIDE.
To obtain the best cutting results, the mower housing
should be adjusted so that the front is approximately 1/8" to
1/2" lower than the rear when the mower is in its highest
position.
Check adjustment on right side of tractor_ Measure dis-
tance"D" directly infront and behind the mandrel at bottom
edge of mower housing as shown.
•
Before making any necessary adjustments, checkthat
both front links are equal in length. Both linksshould be
approximately 10-3/8".
°
If links are not equal in length, adjust one link to same
length as other linko
°
To lower front of mower loosen nut "E" on both front
links an equal number of turns°
°
When distance "D" is 1/8" to 1/2" lower'at front than
rear, tighten nuts "F" against trunnion on both front
links.
°
To raise front of mower, loosen nut"F" from trunnion on
both front links. Tighten nut "E" on both front links an
equal number of turns.
•
When distance "D" is 1/8" to 1/2" lower at front than
rear, tighten nut"F" against trunnion on both front links.
•
Recheck side-to-side adjustment.
MANDREL
SUSPENSION
ARM
LIFT LINK
ADJUSTMENT NUT
FIG. 22
22
FIG. 23
BOTH FRONT LINKS MUST BE EQUAL IN LENGTH
.......
_
NUT "E"
NUT
FRONT LINKS
TRUNNION
FIG. 24