Assembly Of Hopper Bag; Rear Hopper Tube; Upper Hopper Tube; Lower Hoppertube - Craftsman 486.242223 Owner's Manual

ASSEMBLY OF HOPPER BAG
STEP 12: (SEE FIGURE 10)
• Fit the ends of the two upper hopper tubes into the
ends of a rear hopper tube. Align the holes in the
ends of the tubes and secure them in place using two
curved head bolts (E) and nylock nuts (F).
• Fit the ends of the two lower hopper tubes into the
ends of a rear hopper tube. Align the holes in the
ends of the tubes and secure them in place using two
curved head bolts (E) and nylock nuts (F).
NOTE: Either side of the rear hopper tube can face up.
REAR
HOPPER
TUBE
NYLOCK
NUT(F)
CURVED HEAD
BOLT (E)
UPPER
HOPPER
TUBE
REAR
HOPPER
TUBE
NYLOCK
NUT (F)
J
CURVED
BOLT (E)
LOWER
HOPPERTUBE
FIGURE 10
STEP 13: (SEE FIGURE 11)
• Unfold the hopper bag, reverse the fold of the mesh
wind screen and then lay the bag out fiat with the
wind screen on top.
• insert the ends of the assembled upper hopper tubes
down through the stitched sleeves in the sides of the
hopper bag and then slide the tubes back underneath
the wind screen.
STITCHED SLEEVE
UPPER
HOPPER
TUBE
HOPPER
BAG
BOTTOM
FIGURE 11
STEP 14: (SEE FIGURE 12)
• Place the assembled lower hopper tubes into the
bottom of the hopper bag and then slide the tubes to
the back of the bag.
• Attach the ends of the lower hopper tubes to the
inside of the upper hopper tubes using two clevis
pins (L) inserted from the inside, and two hair cotter
pins (M).
UPPER HOPPER
/
LOWER HOPPER TUBE
HAIR COTTER
PiN (M)
\
P
CLEVIS PIN (L)
HOPPER BAG
BOTTOM
FIGURE 12
8