Setting Surface Controls; Usingthe Touchcontrol - Electrolux E30IC75FSS5 Use & Care Manual

Setting Surface Controls
THETOUCHCONTROL
[] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] []
Fig. 22
The recommended way to use the touch pads on the cooktop is shown
in Fig. 22. Be sure that your finger is placed in the center of the touch
pad as shown. If the finger is not placed on the center of a pad, the
cooktop may not respond to the selection made.
Lightly contact the pad with the flat part of your entire fingertip. Do not
just use the narrow end of your fingertip.
OPE T NG THECOOKINGZONES
[] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] []
The Induction cooktop has four Cooking Zones designed for cookware of various sizes.
Be sure to place cookware that meets the minimum and maximum pan size requirements
(Fig. 19) for the Cooking Zone desired and is best for the amount of food being prepared.
Place the cookware with the prepared food on the Cooking Zone BEFORE setting any of
the Cooktop controls.
To Turn ON one or more of the Cooking Zones:
1. Place the prepared food using the correct type and size cookware on the desired
Cooking Zone. Be sure to center the cookware on Cooking Zone completely covering
the minimum ring marked on the Zone surface. PLEASE NOTE: If the cookware
requirements for the Cooking Zone (See Fig. 20) are not met the sensors will detect a
problem and display the letter Fin the affected Cooking Zone LED. Any problems
must be corrected before proceeding.
2. Touch and hold the (_ key pad for 2 seconds (or until a beep sounds). The Power
PCWER
Indicator light located above the C) key pad will turn ON. NOTE: If no other key pad
POWER
is touched within 10 seconds the request to Power ON the cooktop will clear.
3. To start one or more of the four Cooking Zones lightly touch the (_ key pad for the
On/Off
Cooking Zones needed. A beep will sound and the chosen Cooking Zone power level
digital display will show 0 indicating no power level for the Zone has been set yet.
NOTE: If no other key pad is touched within 5 seconds the request to Power ON the
Cooktop Zone will clear.
4. Set the desired power level for the Cooking Zone by touching either the _ or _:7 key
pad. If the _ key pad is touched the Cooking Zone will start at a "Power Boost"
maximum power level (the Cooking Zone LED will display P and the control will beep
once). If the _ key pad is touched once the Cooking Zone will start at 1.0 (the
Cooking Zone LED will display 7 and the control will beep once).