Table of Contents
Advertisement
VENT-FREE
NATURAL
GAS COMPACT
FIREPLACE
OPERATING
FIREPLACE
Continued
l
TO TURN OFF GAS
TO APPLIANCE
Shutting
Off Heater
1.
Turn control knob clockwise
to the OFF position.
2a. Set selector switch in the OFF position.
2b. If Using Optional
Hand-Held
Re-
mote: Set selector switch in the OFF
position to prevent draining battery.
NOTICE: You must light the pilot
before using the hand-held
re-
mote control unit. See Lighting
Instructions on page 15.
1.
After lighting, let pilot flame burn for
about one minute. Turn control knob
to ON position. Adjust flame adjust-
ment knob anywhere
between HI
and LO. Slide the selector switch to
the REMOTE position. NOTE: The
burner may light if hand-held remote
ON button was on when selector
switch was last turned off. You can
now turn the burner on and off with
the hand-held remote control unit.
Shutting Off Burner Only (pilot
stays lit)
You may shut off the burner and keep the
pilot lit by doing one of the following:
1.
Turn control knob clockwise
to the PILOT position.
2.
Use remote control manual OFF button_
3.
Set selector swltch in the OFF position.
l
MANUAL
LIGHTING
PROCEDURE
1.
Follow steps 1 through 6 under Light-
ing Instructions, page 15.
2.
Depress control knob and tight pilot
with match.
Keep control knob pressed in for 30
seconds after lighting pilot. After 30
seconds, release control knob. Now
follow steps 9 through 11, page 15.
.
l
OPTIONAL REMOTE
OPERATION
l
Note: All remote control accessories must
be purchased separately
(see Accessories,
page 24). Follow installation instructions
on pages 14 of this manual.
Thermostat
Control
Operation
(Optional CGHRCT Series Only) The
thermostat
control setting on the remote
control unit can be set to any comfort level
between HI and LO. The burner will turn
on and off automatically to maintain the
comfort level you select. The ideal comfort
setting will vary by household depending
upon the amount of space to be heated, the
output of the central heating system, etc.
IMPORTANT: Do not leave the selec-
tor switch in the REMOTE position
when the pilot is not lit.This will drain
the battery.
IMPORTANT: Be sure to press the
ON/OFF buttons on the hand-held
remote control unit for up to 3 sec-
onds to assure proper operation.
CGHRC
Operation:
2a. Press the ON/OFF button to turn the
burner on and off. When turning
burner off, the pilot will remain lit.
CGHRCT
Operation:
2b. Select the MAN (manual) or AUTO
button on the hand-held remote con-
trol unit (see Figure 28, page 17).
• In manual mode, turn burner on
or off by pressing the ON or OFF
buttons on the hand-held remote
control unit.
3.
4.
• In auto mode, the room tempera-
ture is controlled by the thermo-
stat in the hand-held remote con-
trol unit. To increase the room tem-
perature, press the top arrow of the
TEMP button. To lower room the
temperature, press the bottom ar-
row of the TEMP button. At higher
settings the heater will run more.
iMPORTANT:
This remote control
has been specially engineered to take
an air temperature
sample every 5.5
minutes in the AUTO mode. It will not
respond immediately to the tempera-
ture setting being turned up or down.
IMPORTANT:
The hand-held
re-
mote control unit must be near the
heater. Do not keep the hand-held
remote control unit too close to the
heater. The thermostat
on the hand-
held remote control unit will heat up
too quickly and turn the heater off.
Use the STATUS button on the hand-
held remote control unit to see the
operation mode being used and the
temperature setting selected. A red
light will come on beside the opera-
tion mode being used when the sta-
tus button is pressed (see Figure 28,
page 17).
To turn the burner off when operating
in the manual mode, press the OFF
button. If operating in the auto mode,
press the MAN button, then press the
OFF button. The pilot will remain lit
(see Figure 28, page 17).
IMPORTANT: To turn the pilot off,
manually turn the control knob on the
heater to the OFF position.
Selector Switch in Remote
Control Knob
Position (Optional Remote Control)
Figure 27- Setting the Selector Switch, Control Knob, end Flame Adjustment Knob for
Remote Operation
16
105617
Advertisement
Table of Contents
