Craftsman evolv 900.24543 Instruction Manual page 7

MOTOR
Be sure your power supply agrees with
nameplate marking. 120 Volts AC only
means your too( will operate on stamdard
60 Hz household power, Do nol operate
AC tools on DC.A rating of !20 volts
AC/DC means lhatyour tool will operate
on standard 60 Hz AC or DC power. This
information is printed on thenameplate.
Lower voltage will cause _oss of power and
can result in over-he_ng. AI Cra_ Evdv
tools are !actory-tested; i! this too&does not
operate, chock the power supply.
AUXIliARY HANDLE (FIG. 1)
An auxiliary handle (5) is furnished with
your grinder and can be screwed into
TIMES to maintain complete control of the
toot, TIGHTEN SECURELY,
STARTING AND STOPPING THE TOOL
To start the too&,slide the ON/OFF switch
forward (1). For contir.JouS operation.
slide the switch(2) fully !orward and press
front end down. To stop the tool. release the
ON/OFF switch. To stop the tool while
punning in continuous mode, press the
rearward part ol the switch.
NOTE: Do nol switch the tool on or off
while under load conditions, Allow the
grinder to runup to fu&¢ s peed before
touching the surface to be ground. Lift the
tool !tom,he sudace before turrfing the
tool off. _CALmON: Allow the tool to
stop be!ore setting down,
OVERLOAD
Overloading wig cause damage to the
motor olyour angle gdnder. This can
happen if your angle grinder is subjected
to heavy use !or prolonged periods of time,
Do not in any circumstances, attempt to
exert too much pressure on your angle
grinder to speed up your woek.
The abrasive discs operate more efficiently
when light pressureis exerted, thus avoiding
a drop in the speed of your angle grinder.
ATTACHING THE WHEEL GUARD (FIG. 2)
Place the flange (1t) over the spindle
with the protrusions facing towards the
Uakard,
e sure that the screws are tight and
that the guard can be rotated,
FITTING DEPRESSED CENTER
WHEELS (RGS. 3,4,5,6)
Turn off and unplug the tool.
A CAUTION: Never use any grinding
wheels without the proper guard.
!. Ensure that 1he guard is tilted property.
Place the irmer flange (12) ort the
spindle (9) as shown (Fig. 3). Ensure
that il is located on the two !lats,
@
Turn off and unplug the tool. NEVER GRIND
OR BRUSH WITHOUT GUARD IN PLACE.
, Place the angle grinder on a table, spindle
(9) lacing up.
• Placing the s_ng washer (8) over the
sp_dle and tocate iton the shoulder (i 0).
, Place the guard onto the toot as shown,
7