Craftsman evolv 900.24543 Instruction Manual page 10

Maintainan angle betweenthe disc and
worksudace (Fig. !!
)
Ol approximately
30' when grinding and t0°-15 ° when
sanding ( Fig. t2) for best tool control,
material removal, and minimal loading,
A, WARNING: Always wear eye
protection while operating thls power
tool including face end body
protecUon when brushing.
exposed to heat may require more
frequent Iubrication.)This lubrication
shou|d be attempted only by trained power
tool repair specialists such as those at
Sears Service Centers or in other qualilied
service organizatior_s.
REPLACEMENT GRINDING WHEEL
Replace the gdnding wheel with a
Craftsman 4-1/2 inch Type 27, available
at Sears stores and other Craltsrnar_
outlets.
30
®
15
CLEANING
B|owing dust and grit out of the motor
housing using compressed air is a
necessary maintenance procedure.
A CALrlrlON: Dust and grit f_om metal
grinding o!ten accumulate on interior
sudaces and could create an electrical
shock hazard i! not cleaned out,
Use only mild soap and a damp cloth to
clean the tool. Never let any liquid gel
inside the tool; never immerse any part of
the Iool into a liquid.
IMPORTANT: To assure product SAFETY
and RELIABILITY, repairs, maintenance
and adjustment shouid be performed by
Sears Service Centers.
LUBRICATION
Craftsman Evofv tools are propedy
tutxicated at the factory and are ready for
use, Tools shou|d be lutx_cated regularly
every year depending on usage. (Tools
used on heavy duty jobs and tools
10