Craftsman 315.CR2100 Operator's Manual page 5

• For best results, your blower battery should be
charged in a location where the temperature is
more than 50°F but less than 100°F. Do not store
outside or in vehicles.
• Under extreme usage or temperature conditions,
battery leakage may occur. If liquid comes in con-
tact with your skin, wash immediately with soap
and water. If liquid gets into your eyes, flush them
with clean water for at least 10 minutes, then seek
immediate medical attention. Following this rule will
reduce the risk of serious personal injury.
• Do not incinerate this blower even if it is severely
damaged. The batteries can explode in a fire.
• Blower service must be performed only by qualified
repair personnel. Service or maintenance performed
by unqualified personnel may result in a risk of injury.
• When servicing a blower, use only identical replace-
ment parts. Follow instructions in the Maintenance
section of this manual. Use of unauthorized parts or
failure to follow Maintenance Instructions may create a
risk of shock or injury.
• Never use blower near fires or hot ashes. Use near
fires or ashes can spread fires and result in serious
injury and/or property damage.
• Never use blower to spread chemicals, fertilizers, or
any other toxic substances. Spreading these sub-
stances could result in serious injury to the operator or
bystanders.
• Never place blower on any surface, except a hard,
clean surface when motor is running. Gravel, sand,
and other debris can be picked up by the air inlet and
thrown at the operator or bystanders, causing possible
serious injuries.
• Save these instructions. Refer to them frequently and
use them to instruct others who may use this tool. If you
loan someone this tool, loan them these instructions also.
CALIFORNIA PROPOSITION 65
_k WARNING: This product and some dust created by power sanding, sawing, grinding, drilling, and other
construction activities may contain chemicals, including lead, known to cause cancer, birth defects or other
reproductive harm. Wash hands after handling.
Some examples of these chemicals are:
• lead from lead-based paints,
• crystalline silica from bricks and cement and other masonry products, and
• arsenic and chromium from chemically-treated lumber.
Your risk from these exposures varies, depending on how often you do this type of work. To reduce your exposure
to these chemicals: work in a well ventilated area, and work with approved safety equipment, such as those dust
masks that are specially designed to filter out microscopic particles.
SAVE THESE INSTRUCTIONS
5 -- English