Denon AVR-786 Operating Instructions Manual page 13

Easy Setup and Operation Easy Setup and Operation
• These errer screens may be displayed when performing Auto Setup measurement and the autematic measurements can not be
completed because ef the speaker arrangement, measurement envirenment, or ether facters. Please check the folk)wing matters,
reset the pertinent items, and measure again.
• When there is too much noise in the room, the speakers may net be detected properly. Sheuld this happen, perform the
measurements when the noise level is low, er switch off the power of the equipment that is producing the neise for the duration
of the measurements.
J 1-1. Auto Setup
> Front
Retry_
Cancel4
J 1-1. Auto Setup
> Front
Retry_
Cancel_
Skip4
J 1-1. Auto Setup
tm
_BJ
>Exit_
i 1-1. Auto Setup
i * t I -
J Press Enter or Cursor
J Down to Return to
i Auto Setup Menu
.............................................................................................................................................................................................................. _i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_!_i_i_iiiiiiiiiiiiiiiiiiiiiiiiii
11. This screen will be displayed when the speakers
required fer preducing suitable repreduction have
net been detected.
• The front L er front R speaker was net preperly
detected.
• Only one channel of the surreund speakers was
detected.
• Sound was output from the R channel when onlv
one surround back speaker was connected.
• The surround back speaker was detected, but the
surround speaker was net detected.
12] This screen will be displayed when the speaker
pelaritv is cennected in reverse.
_._.: T his screen will be displayed when accurate
measurements cannet be made due to the input
level of the micrephone being tee high.
4 This screen will be displaved when the
measurement micrephone is net cennected.
• Check that the pertinent speakers are
preperly connected.
• Check the polaritv of the pertinent
speakers. Fer some speakers, this
screen may be displayed even theugh
the speakers are preperlv cennected. If
so, select "Skip._".
• Set up the speakers se that their pesitien
is farther awav from the listening
pesitien.
• Lower the w)lume ef the subweefer
speaker.
• Connect the measurement micrephone
te the microphone connector.
Press the
CURSOR
A or V button to select an
item. then press the ENTER button.
'- AU[O Se[uo
-Co_3 e_e-
S[ea_et Cent g :heck
Delay Time Chec
Channe Leve Check
Store_
Retry4
Cance q
'_ Tle measurement
resul[s 31
eacn ii:er'r can De cnecKea
here
1 Press the
ENTER
button.
• The veril car an screen
aeDears.
Example: Seeaker Config. Check
S[eaKer Conf g ]heck
Fro_t SD, _arge
Center SD Sma
Surrounc So Sma
S Back So Sma
S Back S_ 2so
Subwoofer Yes
Press the ENTER button again once you have
checked the results.
10
I ENGLISH I