Setting Management Features - Lenovo ThinkPad T430s User Manual

Note: The Remote Initial Program Load (RPL) function cannot be used with your computer.
Wake on LAN
A network administrator can use Wake on LAN to turn on a computer from a management console.
When Wake on LAN is used with network management software, many functions, such as data transfer,
software updates, and Flash updates of UEFI BIOS, can be performed remotely without remote attendance.
This updating process can be done after normal working hours and on weekends, to save time and increase
productivity. Users are not interrupted during normal working hours, and LAN traffic is kept to a minimum.
If a computer is turned on by the Wake on LAN function, the Network Boot sequence is used.
Asset ID EEPROM
The Asset ID EEPROM contains information about the system, including its configuration and the serial
numbers of key components. It also includes a number of blank fields in which you can record information
about the end users in your network.

Setting management features

To enable the network administrator to control your computer remotely, you must configure the network
interface by setting the system-management features in the ThinkPad Setup program. You can configure
the following functions in the program:
• Wake on LAN
• Network Boot sequence
• Flash update
If an administrator password (supervisor password) has been set, you will need to specify it when you start
ThinkPad Setup to use these functions.
Wake on LAN
When the Wake on LAN feature is enabled on a computer that is connected to a LAN, a network administrator
can start the computer remotely from a management console, using remote network-management software.
When your computer is not under the network administrator's system management, you can disable Wake
on LAN.
To enable or disable Wake on LAN, do the following:
1. Start ThinkPad Setup.
2. Select Config. The Config submenu is displayed.
3. Select Network. The Network item submenu is displayed.
4. For Wake On LAN, select one of the following: AC Only, AC and Battery, or Disabled.
5. Press F10 to save changes and exit.
Network Boot sequence
When your computer is turned on remotely, the system will try to boot from the device that is specified in the
Network Boot setting, and then follow the boot order list on the Boot menu.
To define a sequence, do the following:
1. On the ThinkPad Setup program menu, select Startup. The submenu is displayed.
2. Select Network Boot and press the Enter key. The boot device list is displayed.
128
User Guide