Duplex (Double-Sided) Printing - Oki PRO510DW Printing Manual

D (
UPLEX DOUBLE
If your printer has a duplex unit installed you can print on both
sides of the paper, to save paper, weight, bulk and cost.
NOTE
If this choice does not appear in the driver screens, or if it is
greyed out, check to ensure that the hard disk is enabled in
the printer driver.
page
> Only paper can be used for duplex printing, not
transparencies or other media.
> Use paper stock of 75–188 g/m² maximum. If you
experience excessive curling with 75–90 g/m² paper, use
105 g/m².
Paper weights are given as a guide only and may not
be available for use with your printer. Always check
the paper weight specifications in your User's Guide
before printing. Do not exceed the recommended
paper weight specified.
> Use standard sized paper stock only, e.g. A4, A3, Letter,
etc.
> Load the paper print side up. Ream wrappers are usually
marked with an arrow, indicating which is the print side.
> Paper can be fed from standard paper trays, including the
high capacity feeder if you have one.
NOTE
For paper stock greater than 120 g/m² use the multipurpose
tray.
> Do not set the paper weight to Ultra Heavy.
> Do not enable the White Page Skip function.
- )
SIDED PRINTING
(See "Setting the driver device options" on
13.)
CAUTION!
Finishing options > 80