Troubleshooting - Escort PASSPORT SR7 Owner's Manual

Troubleshooting

Problem Solution
Passport beeps briefly at the same • An X-band motion sensor or intrusion alarm is located within
location every day, but no radar range of your route. With time, you will learn predictable
source is in sight. patterns of these signals.
Passport does not seem sensitive to • Passport may be in City Mode.
radar or laser. • Radar band(s) are turned off in programming.
Passport did not alert when a police • VASCAR, (Visual Average Speed Computer And Recorder) a
car was in view. stopwatch method of speed detection, may be in use. Officer
may not have radar or laser unit turned on.
Passport did not provide a Safety • Safety transmitters may not be commonly used in your area.
signal while within range of an
emergency vehicle.
Passport's audible alerts are less • Passport is in AutoMute Mode. See page 5 for details.
loud after the first few alerts.
Passport's power-on sequence • A loose power connection can cause Passport to be briefly
reoccurs while you are driving. disconnected, and will retrigger the power-on sequence.
Your 14-year old son has changed all • You can return all of the programming options to the factory
9 of the EZ-Programming options. defaults by holding down the City and Mute buttons while you
turn Passport on.
Passport will not turn on. • Check that volume control is ON.
• Check that vehicle ignition is ON.
• Check all connections.
Passport's Display feels warm. • It is normal for Passport to feel warm.
20
Troubleshooting
Explanation of Displays
LsrF ERR
There is a problem with the front Laser Receiver. There could be an unplugged
connection, damaged wiring, or a problem with the front Laser Receiver. After
Passport alerts you to this, it will then resume operation with the front radar receiver
and rear laser only.
LsrR N/A
There is a problem with the rear Laser Receiver. It could be an unplugged connection,
damaged wiring, or a problem within the rear Laser Receiver itself. After Passport alerts
you to this, it will then resume operation with the front radar and Laser Receiver only.
Check
There is a problem with the front receiver. It could be an unplugged connection,
Receiver
damaged wiring, or a problem within the front receiver itself. Passport will continue
Wiring
to display this message, and will not operate until the problem has been repaired.
HD
Sensitivity control is in Highway mode, display is in Dark Mode (page 13)
AD
Sensitivity control is in Auto mode, display is in Dark Mode (page 13)
CD
Sensitivity control is in City mode, display is in Dark Mode (page 13)
PilotHWY
One of the many programming messages (pages 9-13)
WorkZone
One of the many Safety Radar messages (page 19)
X | ,or K | ,
Passport has been programmed in the ExpertMeter Mode (pages 7-8)
or KA | ,etc.
Self Cal
Passport is running a self-calibration test.
Rcvr ERR
Passport's radar receiver has failed to calibrate. Contact your Dealer for repair.
ShiftOFF
Optional Laser Shifters were manually shut off during a laser alert.
Comm ERR
Serial communications between the interface and the display have been interrupted.
Contact your dealer for repair.
21