Checking Operational Charging; Checking The Battery Pack; Checking The Backup Battery - Lenovo ThinkPad Edge E220s Hardware Maintenance Manual

Hardware maintenance manual
Hide thumbs Also See for ThinkPad Edge E220s:
Table of Contents

Advertisement

3
2
1
Note: Output voltage across pin 2 of the ac power adapter might be different from the one you are
servicing.
3. If the voltage is not correct, replace the ac power adapter.
4. If the voltage is acceptable, do the following:
• Replace the system board.
• If the problem persists, go to "FRU tests" on page 27.
Note: Noise from the ac power adapter does not always indicate a defect.

Checking operational charging

To check whether the battery charges properly during operation, use a discharged battery pack or a battery
pack that has less than 50% of the total power remaining when installed in the computer.
Perform operational charging. If the battery status indicator or icon does not turn on, replace the battery pack.
If the charge indicator still does not turn on, replace the system board.

Checking the battery pack

Battery charging does not start until the Power Manager Battery Gauge shows that less than 96% of the
total power remains; under this condition the battery pack can charge to 100% of its capacity. This protects
the battery pack from being overcharged or from having a shortened life.
To check your battery, move your cursor to the Power Manager Battery Gauge icon in the icon tray of the
Windows taskbar and wait for a moment (but do not click), and the percentage of battery power remaining
is displayed. To get detailed information about the battery, double-click the Power Manager Battery
Gauge icon.
Check the main battery status good or not by using Power Manager. Make sure that the power scheme in
Power Manager is Always Fully charge.

Checking the backup battery

Do the following:
1. Disable the battery pack in UEFI BIOS (see "1000 Disabling the battery pack in UEFI BIOS" on page 50).
2. Remove the backup battery (see "1040 Backup battery" on page 56).
3. Measure the voltage of the backup battery. See the following figure.
(20V)
Pin
Voltage (V dc)
1
+20
2
0
3
Ground
.
Chapter 3
General checkout
31

Advertisement

Table of Contents
loading

This manual is also suitable for:

Thinkpad edge s220

Table of Contents