HP XP P9500 Release Note page 16

9. Do not perform PPRC operation to the BCM copy pairs. If you performed PPRC operation to the
BCM copy pairs, dissolve and re-establish them by BCM. But only if you performed CSUSPEND
operation with default operands on the BCM copy pairs as Cnt Ac-S copy group without the C/T
group ID, you can resynchronize such copy pairs with CESTPAIR operation with default operands.
10. If there is already a configuration file that was generated by the YKP2A command of the Mainframe
Agent program, make sure to use the different prefix value for BCM so that not reference the
configuration file generated by the YKP2A command. BCM does not accept a configuration file
generated by the YKP2A command. If such file is given for any BCM operations, it causes an
error.
1 1. With BCM versions earlier than V6.1, user SVCs cannot be used to suppress output of IOS002A
messages when the I/O path between the host and the DKC is disconnected while disk scanning
is being performed. Therefore, in a mixed-version environment, make sure to always use user
SVCs of BCM version V6.1 or later.
Determining current version
1. The Main Menu panel displays the version number of this product as follows: Release 6.6.1-01
2. The Setting Information panel displays the version number of this product as follows: Version
6.6.1-01 (00)
3. YKT400I message that is produced by using the YKDSPENV command contains the version number
of this product as follows: 6.6.1-01
4. YKY001I message that is produced upon starting up Agent contains the version number of this
product as follows: 06-61–/A
5. The YKENV command displays the version number of this product as follows: 6.6.1-01(00)
6. YK8001I message that is produced upon starting up BCM Monitor contains the version number
of this product as follows: 6.6.1-01
7. Replace CHYKnnn and Vnnnnn as follows:
Table 21 Versioning Replacements
In the manual
CHYKnnn
Vnnnnn
16 Determining current version
Replace with
CHYK634
V066101