HP XP P9500 Manual page 262

Table 64 Error codes (part code 7010) (continued)
Part Error
Code Number
7010 8658
7010 8659
7010 9002
7010 9005
7010 9101
7010 9102
7010 9108
7010 91 10
7010 9303
7010 55003
7010 55004
7010 59000
7010 59048
7010 59069
7010 66102
7010 66560
7010 69025
262 Message (part code group 7nnn)
Error Message
Some settings could not be applied
normally. Refer to the error code.
The PCB required for this operation is
not mounted. Check the subsystem
configuration.
The requested operation has completed.
An error occurred. Check the error code.
Do you want to cancel?
Do you want to apply?
The option has been changed. If you
continue processing before applying the
change, the option will be reset to the
current setting. Do you want to continue
processing?
Do you want to execute the Initialize
operation?
There are no valid volumes.
The volume in the pair status is included
in the selected S-VOL.
The number of selected P-VOLs is not
corresponding to the number of selected
S-VOLs.
The CLPR used for the P-VOL differs from
the CLPR used for the S-VOL. Do you
want to continue this operation?
The P-VOL and the S-VOL belong to
different SLPRs. Do you want to continue
this operation?
The P-VOL and the S-VOL belong to
different SLPRs. If you perform this
operation, the storage partition
administrator will become unable to
operate.
Do you want to continue this operation?
Information was updated by other users.
The list will scroll to the top.
The maximum number of Pairs or
Volumes that can be displayed in the
Preview List is 16,384. Change the
number of pairs or volumes that is
displayed in the Preview List to 16,384
or less.
Some pairs are excluded from the pairs
to be set, because pairs in invalid status
Recommended Action
Check the error code in the Preview list.
Mount the required PCB, then retry the
operation.
The operation ended normally. Execute
the next operation.
An error occurred during the indicated
operation. See the error code for each
operation in the Preview list.
To cancel, click [OK].
Click [OK] to execute the operation.
To continue processing, click [OK].
Otherwise, click [Cancel].
To continue processing, click [OK].
Otherwise, click [Cancel].
Check the device emulation and the
definition of the SCSI path.
Check the selected S-VOL.
Correct the number of selected P-VOLs
and S-VOLs.
To continue the operation, click [OK].
Click [Cancel], then please contact HP
Technical Support.
Please contact HP Technical Support.
Click [OK], then continue the operation.
Change the number of pairs or volumes
displayed in Preview to 16,384 or less.
Change the status of the excluded pair.
Pairsplit operation cannot be executed
Severity
Level
W
W
i
i
i
i
i
W
i
W
W
W
E
E
W
W
W