HP Surestore 40fx - Optical Jukebox Manual page 10

12. Connect the drive power, SCSI, and drive interface cables to the new drive.
Connect the cables to the bottom drive first, then the top drive.
Use the end connector on the SCSI cable to go to the top drive. Use either power connector on the
drives. Use the longer drive interface cable to reach the top drive.
13. Mount the front RFI shield.
14. Thread the front panel cable up the front of the RFI shield and through the clip on the top of the
shield.
15. Re-mount the front bezel.
Before placing the front bezel against the chassis, connect the front panel cable and the mailslot
sensor cable connectors to the front panel PCA,
16. Release the T-25 screw holding the picker in its stowed position at the top of the chassis.
17. Connect the power cable. Turn the jukebox on.
18. Run Test 2, the Wellness Test, to verify that the upgrade has been successful.
19. Re-mount the access panel and outside cover.
10
Figure 9: Front panel clip on RFI shield