Figure 1-3 . Connecting A 10-Drive Jukebox, Two Host Adapters, Basic Scsi; Addressing - HP Surestore 1200ex - Optical Jukebox User Manual

Hp surestore optical disk jukeboxes user's guide - c1104-90015
Hide thumbs Also See for Surestore 1200ex - Optical Jukebox:
Table of Contents

Advertisement

4. Remove the customer access panel by pulling on the bottom of the panel and
then lifting it off (see Figure 1-1). (If screws are installed, use a flatblade
screwdriver or T-15 Torx driver.)
Figure 1-3
Connecting a 10-Drive Jukebox, Two Host Adapters, Basic SCSI Addressing
5. Plug a SCSI terminator into the unused SCSI connector of interface type you
chose (the example diagram shows terminators for the two differential interfaces
placed on the "B1" port for each interface ).
If you are using the differential interface, use a 68-pin high-density terminator.
If you are using the single-ended interface, use a 50-pin high-density terminator.
6. Plug a SCSI terminator into one of SCSI ports on each unused interface (the
example diagram shows the terminators on the single-ended port at "A2" for
both interfaces). The terminators can be placed on either port of the unused
interface.
Use a 50-pin high-density terminator for the single-ended interface or a 68-pin
terminator for the differential interface.
7. To continue with the installation, go to "Connecting Power" in this Chapter.
Chapter 1
Connecting a 10-Drive Jukebox as the Only Peripheral, Two Host
Setting Up the Jukebox
Adapters, Basic SCSI Addressing
1-13

Advertisement

Table of Contents
loading

This manual is also suitable for:

Surestore 660ex

Table of Contents