Table of Contents
Advertisement
Replacing
Batteries
Turn the camera off and make sure that the power-on lamp and the monitor have gone out
before removing or inserting batteries.
Additional
Precautions
Regarding
Batteries
• Read and follow the warnings and cautions on pages iii-iv and 109 of this manual.
• Do not combine old and new batteries or batteries of different
makes or types.
• Batteries with the following
defects cannot be used:
Batteries
with
peeling
Battery
Type
Batteries
with
insulation
that
does not cover the area
around
the
negative
terminal.
Batteries
with
a flat
negative
terminal
To improve battery performance,
select the type of battery currently inserted in the camera in
the setup menu. The default setting is [Lithium]. When any other type of battery is used, turn
the camera on and change the setting ([]
105).
[]
Alkaline
Batteries
Performance of alkaline batteries may vary greatly depending on the manufacturer.
Choose a
reliable brand.
[]
Alternative
Power
Resources
To power the camera continuously
for extended
periods, use an EH-65A AC adapter
kit
(_1_106). Do not, under
any circumstances,
use another
make or model of AC adapter.
Failure to observe this precaution could result in overheating
or in damage to the camera.
[]
Power
Saving
Function
in Shooting
Mode
The camera adjusts monitor brightness according to the brightness
of the surroundings
to
save power. When no operations
are performed for fifteen seconds, the monitor turns off
and the power-on
lamp blinks. If no operations are performed for another fifteen seconds,
the camera enters standby mode. To reactivate the camera, press the shutter-release
button
halfway. If no operations are performed in standby mode for another three minutes, the cam-
era turns off.
The amount of time allowed to pass before the camera enters standby mode can be specified
from the auto off menu (_
100).
-o
6"
o
o
11
Advertisement
Table of Contents
