Table of Contents
Advertisement
This equipment
has been tested
and found to comply
with the limits for an Other Class B digital
device,
pursuant
to Part 15 of the
FCC Rules. These
limits are designed
to provide
reasonable
protection
against
harmful
interference
in a residential
installation.
This equipment
generates,
uses and can radiate
radio frequency
energy
and, if not installed
and used in accordance
with the
instructions,
may cause harmful
interference
to radio communications.
However,
there is no guarantee
that interference
will not
occur in a particular
installation.
If this equipment
does cause
harmful
interference
to radio or television
reception,
which
can be
determined
by turning
the equipment
off and on, the user is encouraged
to try to correct
the interference
by one or more of the
following
measures:
• Reorient
or relocate
the receiving
antenna.
• Increase
the separation
between
the equipment
and receiver.
• Connect
the equipment
into an outlet on a circuit different
from that to which
the receiver
is connected.
• Consult
the Panasonic
Service
Center or an experienced
radio/TV
technician
for help.
FCC Caution:
To assure
continued
compliance,
follow
the attached
installation
instructions
and use only
shielded
interface
cables
when
connecting
to peripheral
devices.
Any changes
or modifications
not expressly
approved
by Panasonic
Corp.
of
North
America
could
void
the user's
authority
to operate
this device.
FCC and Industry
Canada
(IC) RF Exposure
Warning
:
• This TV is provided
with
two USB ports on rear enclosure
for exclusive
dedicated
use for insertion
of the following
optional
transmitters:
(1) Wireless
LAN Adapter
with
FCC ID:HSN-WLU5150/IC
ID:I353A-WLU5150;
and (2) Bluetooth
Adapter
with
FCC ID:NKR=DBUBP207/IC
ID:4441A=DBUBP207.
• Other
transmitters
shall not be used,
unless
specifically
recommended
when
they
become
available.
Other
third-
party
wireless
transmitters
have not been
RF exposure
evaluated
for use with
this TV and may not comply
with
FCC
and IC RF exposure
requirements.
• The above
two
described
transmitters
comply
with
FCC and IC radiation
exposure
limits set forth
for an
uncontrolled
environment
for mobile
use with
minimum
8 inches
(20 cm) spacing
requirement
between
transmitters
and all person's
body
(excluding
extremities
of hands,
wrist
and feet) during
wireless
modes
of operation.
<Only for Wi-Fi if capable
of transmission
in the 5.15 ~ 5.25 GHz frequency
band>
This product is restricted
to indoor use due to its operation
in the 5.15 to 5.25 GHz frequency
range.
FCC and IC require this product to be used indoors for the frequency
range 5.15 to 5.25 GHz to reduce the potential
for harmful
interference
to co-channel
Mobile Satellite systems.
High power radars are allocated
as primary users of the 5.25 to 5.35 GHz and 5.65
to 5.85 GHz bands. These radar stations can cause interference
with and/or damage this product.
Responsible
Party:
Contact
Source:
email:
Panasonic
Corporation
of North America
One Panasonic
Way, Secaucus,
NJ 07094
Panasonic
Consumer
Marketing
Company
of North America
1-877-95-VIE
RA (958-4372)
consumerproducts(_,panasonic.com
This device
complies
with Part 15 of the FCC Rules and all applicable
IC RSS standards.
Operation
is subject to the following
two conditions:
(1) This device
may not cause harmful
interference,
and (2) this device
must accept
any interference
received,
including
interference
that may cause undesired
operation.
mahout
built-in
wireless
LAN/Bluetooth
_ To use the built-in wireless LAN, an access point needs to be obtained.
;_ Do not use the built-in wireless LAN to connect to any wireless network (SSID *_) for which you do not have usage
rights. Such networks may be listed as a result of searches.
However, using them may be regarded as illegal access.
;_ Check that the Access point supports WPS*L
(If it does not support WPS, the encryption
key of the Access point is required when configuring settings.)
;_ Follow the instructions on the Access point setup screen and configure the appropriate
security settings.
For more details on setting of Access point, please refer to operating manual for the Access point.
;_ We recommend
using 11n (5 GHz) for the wireless system between the built-in wireless LAN and Access point.
Communication
is also possible with 11a, 11b, and 11g (2.4 GHz), but the communication
speed may be slower.
_ If the wireless system of the Access point is changed, devicesthat could connect bywireless LAN may no longerbe able to connect.
® Data transmitted
and received over radio waves may be intercepted
and monitored.
® Keep the TV away from the following devices as much as possible:
Wireless LAN, microwaves,
and other devices that use 2.4 GHz and 5 GHz signals. Otherwise, the TV failures such as
malfunction may occur due to the radio wave interference.
® When noises occur due to the static electricity, etc., the TV might stop operating for the protection of the devices. In
this case, turn the TV Off with power On / Off switch, then turn it On again.
*_SSID is a name for identifying a particular wireless network for transmission.
,2 WPS: Wi-Fi Protected Setup
7
Hide quick links:
Advertisement
Table of Contents
