Advertisement
VUtl,,v.ltu_t_'_an_uwJntw
Ntl-v J_/_
_ltlel&VO]m#Mr,_mlmWllllUll_uu
laae.y_Md IVI_J Illi
rel,:_uhi
)14
T
Your Palmcorder may be connected to a
TV to play backtapes or to view what you
are recording.
(_TV
with AUDIONIDEO
IN Jacks.
To Audio In
Cable
(Supplied)
To Audio/Video
Out
(_TV
without AUDIONIDEO
IN Jacks.
To Audio/
Video Out
RF Adaptor
(optional)
VHF Antenna
300 ohm-T5 ohm
CH 3/4 Switch
transformer
(not supplied)
or F Connector
•
UHF Antenna
vc.=v
Selector
I
Back of TV /
Ceb,a
_
I III
,n..,,.ed) I ll
To VHF Antenna
-_NL---.J
I
Terminal
Before you begin...
* Connect the Palmcorder to a power source.
l
Set the POWER switch to VCR for
tape playback.
Or, set to CAMERA
to view what your
Palmcorder is recording.
Turn the TV ON and set it to LINE
INPUT.
Check your TV operating Instructions.
Note:
If your TV has no VIDEO or AUDIO IN jacks,
select CH 3 or 4 on your TV to match the
CH 3/4 switchsetting on the OPTIONAL
PV-RF16 RF Adaptor. Set the VCR/TV
selector on the RF Adaptor to VCR for
playback.
Start playback
or begin a recording.
If you have connected the
Palmcorder
to your TV using the
PV-RF16 RF Adaptor and want to
watch TV only:
Set the POWER switch to OFF on the
Palmcorder.
Then, set the VCR/'rv Selector on the RF
Adaptor to TV.
Now, turn the TV ON and select a
channel.
rhu.z.h'_
1 I_1SI SI[ wl_.-_.-ruti_
'CATV
System
Installer
This reminder is provided to call the CATV
system installer'sattention to Article 820-4C
of the NEC in USA (and to the Canadian
Electrical Code in Canada) that provides
guidelinesfor proper groundingend, in
particular,specifies that the cable ground
shall be connected to the groundingsystem
of the building, as close to the point of cable
_ntry as practical.
,J
Load Detector
Remove the Battery Compartment
lid
and insert the AA size battery.
• Make sure polaritieeare aligned properly.
• When tape loading and unloadingtime
becomes longer than normal, battery replace-
ment is necessary.
--'1
Turn the Tape Wheel on the
cassette
in the direction
of the
arrow to take up any slack.
Slide the RELEASE
button in the
direction of the arrow to open the
PlayPak door.
Insert the _
cassette
with the
window facing up and to the left.
Then, snap the lid shut.
* Be sure the cassette reel area under the
PlayPak is free to turn while loading.
• Allow the Load Detector to fully retract
before usingthe PlayPak in your standard
VHS VCR.
Slide the RELEASE
button and wait
for the lid to open.
Hold the PlayPak securely
In one
hand. Using your finger, reach through
the hole In the bottom of the PlayPak
Adaptor and push the tape out the top.
Advertisement
