Table of Contents
Advertisement
TROUBLESHOOTING
TABLE
- Continued
TROUBLE
CAUSE
REMEDY
O[I inadequate
t. Oil tank empty
1. Fill oil tank
for bar and
2. Oil pump or oil filter
2 Contact
Sears
Service.
chain
clogged.
lubrication.
3. Guide bar oil hole
3. Remove
bar and clean.
blocked.
Chain moves
at
1. Idle speed
requires
1. See "Carburetor
Adjustment"
in the
idle speed,
adjustment.
Service and Adjustments
Section.
2. Clutch requires
repair.
2 Contact
Sears Service
(see back cover).
Chain does not
1. Chain tension
too
1. See 'Check
Chain Tension"
in the
move when an-
tight.
Maintenance
Section.
gine is acceler-
2 Carburetor
requires
2 See 'Carburetor
Adjustment"in
the
ated.
adjustment.
Service and Adjustments
Section.
3 Guide bar rails
3. Repair or replace.
pinched.
4. Clutch slipping.
5 Chain brake engaged
Chain clatters
1. Chain tension
incorrect.
or cuts roughty.
2 Cutters damaged
3 Chain worn.
4 Cutters dull, improperly
sharpened,
or depth
gauges
too high.
5. Sprocket
worn.
6 Chain installed
backwards.
4. Contact
Sears Service
(see back cover).
5. Disengage
chain brake
t. See "Check
Chain Tension"
in the
Maintenance
Section.
2 Contact
Sears Service
(see back cover).
3. Resharpen
or replace
chain.
4. See "Chain Sharpening"
in the
Service and Adjustments
Section.
5. Contact
Sears Service
(see back cover).
6 install chain in right direction.
Chain stops
1. Chain cutter tops not
t. See "Chain Sharpening"
in the
within the cut.
filed flat.
Service and Adjustments
Section.
2. Guide bar burred or
2 Repair or replace
guide bar
bent; rails uneven.
3 Clutch slipping.
3. Contact
Sears Service
(see back cover).
Chain cuts at
t. Cutters damaged
on
t. See "Chain Sharpening"
in the
an angle,
one side
Service and Adjustments
Section.
2. Chain dul_ on one side.
2 See "Chain Sharpening"
in the
Service and Adjustments
Section.
3. Guide bar bent or worn.
3. Replace guide bar.
If situations
occur
which
are not covered
this
manuaI,
use care
and good
judgement,
if you
need
assistance,
contact
Sears
Service
or the CUSTOMER
ASSISTANCE
HELPUNE
at t-800-235-5878,
YOUR WARRANTY
RIGHTS
AND
OBLIGATIONS:
The U i S( Environ-
mental Protection
Agency
and Sears,
Roebuck
and Co., U.S.A,, are pieased
to expiain the emissions control system
warranty on your year 2001-2004
small
off-road engine,
Sears must warrant
the emission control system on your
small off-road engine for the periods of
time listed betow provided there has
been no abuse, neglect, or improper
maintenance
of your small off-road en-
gine, Your emission control system in-
cludes parts such as the carburetor and
the ignition system, Where a warrant-
abte condition exists, Sears wiii repair
your smaII off-road engine at no cost to
you. Expenses covered under warranty
incIude diagnosis, parts and tabor.
MANUFACTURER'S
WARRANTY
COVERAGE:
If any emissions related
part on your engine (as listed under
Emissions Control Warranty Parts List) is
defective or a defect in the materials or
workmanship
of the engine causes the
failure of such an emission related part,
21
Hide quick links:
Advertisement
Table of Contents
