Craftsman 358.796390 Operator's Manual page 11

2.While holding e ach bolt i nplace
withawrench, retighten thenuts.
/, b
-_-,TOP SIDE
/i/// OF BLADE
\. ...J
CAUTION: If the clearance between
the cutting blades is set too wide, the
blades will not cut correctly. If the
blades are adjusted too tight, over-
heating may occur.
REPLACE SPARK PLUG
Replace spark plug each year to
ensure the engine starts easier and
runs better. Set spark plug gap at
0.025 inch (0.6 mm). Ignition timing
is fixed, nonadjustable.
1. Twist, then pull off spark plug boot.
2. Remove spark plug from cylinder
and discard.
,_/kWARNING: Perform the follow-
3. Replace with Champion RCJ-6Y
spark plug and tighten securely
with a 3/4 inch (19 mm) socket
wrench.
4. Reinstall the spark plug boot.
REPLACE FUEL FILTER
To replace fuel filter, drain unit by ru-
nning it dry of fuel, then remove fuel
cap/retainer assembly from tank.
Pull filter from tank and remove it
from the fuel line. Install new fuel
filter on fuel line; reinstall parts.
Fuel
_ Filter
Fuel Line
ing steps after each use:
• Allow engine to cool, and secure the
unit before storing or transporting.
• Store unit and fuel in a welt ventila-
ted area where fuel vapors cannot
reach sparks or open flames from
water heaters, electric motors or
switches, furnaces, etc.
• Store unit with the blade cover ins-
talled. Position unit so that any
sharp object cannot accidentally
cause injury.
° Store unit and fuel well out of the
reach of children.
SEASONAL STORAGE
Prepare unit for storage at end of
season or if it will not be used for 30
days or more. If your unit is to be
stored for a period of time:
° Clean the entire unit.
° Store in a clean dry area.
• Clean all parts and check for damage.
Have damaged parts repaired or
replaced by an authorized service
dealer.
° Keep all nuts, bolts, and screws
tight.
° Lightly oil external metal surfaces,
including the blade.
° Install the blade cover.
° Empty fuel tank before storage.
To oil the blade, do the
following:
• Stop the engine and allow blade to
come to a complete stop.
• Ensure ON/OFF switch is in the
OFF position.
• Disconnect the spark plug wire.
• Apply a light machine oil along the
edge of the top strap as shown.
-11-