Craftsman 917.273623 Owner's Manual page 11

SAFETYGLASSES
The operation of any tractor can result in foreign objects thrown into
the eyes, which can result in severe eye damage. Always wear safety
glasses or eye shields while operating your tractor or performing any
adjustments or repairs. We recommend standard safety glasses or a
wide vision safety mask worn over spectacles.
HOW TO USE YOUR TRACTOR
TO SET PARKmNG BRAKE
Your tractor is equipped with an operator
presence sensing switch. When engine
is running, any attempt by the operator
to leave the seat without first setting the
parking brake will shut off the engine.
1. Depress clutch/brake pedal all the way
down and hold.
2. Pull parking brake lever up and release
pressure from clutch/brake pedal.
Pedal should remain in brake position.
Make sure parking brake will hold trac-
tor secure.
Attachment
Pushqn to CUutch Switch
Choke "Disengaged" PuH Out To
"Engage"
ThrottUe
Brake _,_
Pedal ..... Motion
"Drive" "Disengaged" ControU Lever
Position Position Parking Brake
STOPPmNG
MOWER BLADES =
To stop mower blades, push attachment
clutch switch in to disengaged position.
GROUND DRIVE -
To stop ground drive, depress clutch/
brake pedal all the way down.
Move motion control lever to neutral (N)
position.
mMPORTANT: The motion control lever
does not return to neutral (N) position
when the clutch/brake pedal is depressed.
ENGINE -
Move throttle control to slow position.
NOTE: Failure to move throttle control to
slow position to allow engine to idle before
stopping may cause engine to "backfire".
Turn ignition key to "STOP" position and
remove key. Always remove key when
leaving tractor to prevent unauthorized
use.
Never use choke to stop engine.
mMPORTANT: Leaving the ignition switch in
any position other than "STOP" will cause
the battery to discharge and go dead.
11
NOTE: Under certain conditions when
tractor is standing idle with the engine
running, hot engine exhaust gases may
cause "browning" of grass. To eliminate
this possibility, always stop engine when
opping tractor on grass areas.
CAUTmON: Always stop tractor com-
pletely, as described above, before leaving
the operator's position.
THROTTLE CONTROL
Always operate engine at full throttle.
Operating engine at less than full throttle
reduces the battery charging rate.
Full throttle offers the best bagging and
mower performance.
TO USE CHOKE CONTROL
Use choke control whenever you are start-
ing a cold engine. Do not use to start a
warm engine.
To engage choke control, pull knob out.
Slowly push knob in to disengage.
TO MOVE FORWARD AND
BACKWARD
The direction and speed of movement is
controlled by the motion control lever.
1. Start tractor with motion control lever in
neutral (N) position.
2. Release parking brake.
3. Slowly move motion control lever to
desired position.
TO ADJUST MOWER CUTTmNG HEmGHT
The position of the attachment lift lever
determines the cutting height.
* Grasp lift lever.
* Press plunger with thumb and move
lever to desired position.
The cutting height range is approxi-
mately 1-1,/2 to 4". The heights are mea-
sured from the ground to the blade tip with
the engine not running.
These heights are approximate and may
vary depending upon soil conditions, height
of grass and types of grass being mowed.
The average lawn should be cut to approxi-
mately 2-1/2 inches during the cool season
and to over 3 inches during hot months.
For healthier and better looking lawns, mow
often and after moderate growth.
For best cutting performance, grass over
6 inches in height should be mowed
twice. Make the first cut relatively high;
the second to desired height.