Table of Contents
Advertisement
•
Before turning on the saw, perform a dry run of the
cutting operation just to make sure that no problems
will occur when the cut is made.
•
Grasp the saw handle firmly, slide the lock-off lever
back, then squeeze the switch trigger. Allow several
seconds for the blade to roach maximum speed.
•
Slowly lower the blade into and through the
workpiece. See Figures 29 and 30.
•
Release the switch trigger and allow the saw blade
to stop rotating before raising the blade out of
workpiece. Wait until the electric brake stops blade
from turning before removing the workpiece from
miter table.
SUPPORT
LONG WORKPIECES
See Figure 31.
Long workpiecas need extra supports. Supports
should be placed along the workpiece so it does not
sag. The support should let the workpiece lay flat on
the base of the saw and_Nork table during the cutting
operation. Use the optional work clamp or a C-clamp
to secure the workpiece,
,_
WARNING:
To avoid serious personal injury,
always keep your hands outside the no hands
zone; at least 3 in. (76.2 mm) from blade. Never
perform any cutting operation freehand (without
holding workpiece against the fence). The blade
could grab the workpiece if it slips or twists.
45° X 45° COMPOUND
MITERCUT
Fig. 30
LONGWORKPIECE
WORKPIECESUPPORTS
23
Fig. 31
Hide quick links:
Advertisement
Table of Contents
