Setting The Channel Tuning Mode - Toshiba 40G300U Owner's Manual

To tune to a channel or input in Select mode:
] While watching TV, press _ "_l or _ _ to open the
Channel Browser
TM
and surf back to a previous item
or t_rward to the next item in the list.
[n Se[ecl mode, when you stop on an item in the
Channel Browser
TM,
it will be highlighted but you
must press @ to tune the TV to the highlighted
item.
2 Press @ to tune the TV to the highlighted item.
EXIT
Press © to close the Channel Browser
TM.
Addingand clearing channelsand inputs
in the History List
Adding channels and inputs to the History
List:
As a channel or input is tuned, the Channel Browser
TM
adds it to the History List and displays it on the "right
side" of the Channel BrowserrrsL Previously tuned
channels/inputs are "shifted" to the left, eventually
Br_c_
moving off the left side. Press _ "_l to surf backward
through the previously tuned channels/inputs. Any
channel or input that is tuned repeatedly will not be
repeated in the History List, but instead is moved to
the end of the list on the right side of the Channel
Browser
TM.
The Channel Browser
TM
will store the following
channels:
,, All channels that are tuned using the numeric buttons
on the remote control.
,, All channels that are tuned using (_ or _J on the
remote control.
Note: Whenever an item is selected that cannot
be tuned (for various reasons), the TV will
automatically tune to the previously viewed
channel or input.
Clearing channels from the History List:
• Reconfiguring the
ANT/CABLE
input will clear the
History List.
Note: See page 30 for details on configuring
the antenna input.
,, Once 32 channels or inputs are stored in the History
List, the oldest item will be removed from the list
when a new channel or input is tuned.
,, Turning off the TV will clear the History List.
Setting the ChannelTuningNode
This feature allows you to choose how tuning will be
handled for analog and digital channels when the TV
is in Antenna mode.
Note: To use this feature, the input Configuration
must be set to Antenna (_, page 30).
The channel tuning mode has three options.
Both analog and digital channels can
Standard
be tuned normally
Digital channels will have priority when
Auto manually entering a channel number
(default) using the Channel Number (0-9) on the
remote control, analoo channels can
still be tuned by (_/_'@, if available
Digital Only digital channels can be tuned
Note: Digital mode will be most useful after
analog channels are shut down by the
government in 2009.
To set the Channel Tuning Mode:
1 From the Setup menu, highlight Installation and
press @. A new set of Installation menu icons
will appear.
Open the Terrestrial menu, highlight Channel
Tuning Nolle, and then press _ to select your
desired mode.
Note:
° The Channel Options windows as well as
the Channel Browser ANT/CABLE list will be
updated automatically when you change the
mode. Also, the History List will be cleared, but
the Favorites List will be saved.
. Even if the Channel Tuning Mode is set to
Digital, analog channel 3 will still be the
default channel to prevent the initial case
where no digital channels have been found in
prior channel scans. (Channel Options will not
have anything listed until a scan is done.)
38