Configuring The Switch; Returning The Failed Component; Additional Information - HP StorageWorks 9100 - Extreme Data Storage System Instructions
Hp storageworks 3gb sas bl switch customer self repair instructions (496787-002, march 2009)
Hide thumbs
Also See for StorageWorks 9100 - Extreme Data Storage System:
- Maintenance and service manual (58 pages) ,
- User manual (50 pages) ,
- Installation instructions (3 pages)
Advertisement
Cabling the switch
After confirming that the desired firmware is installed, connect the SAS
cables to the replacement switch, making sure to connect each cable to
its designated port.
Configuring the switch
If during this replacement you upgrade from single open zone firmware
to multi-zone firmware, you must configure zone groups and assign them
to the servers. Otherwise, the servers will not be able to access the
storage.
Key configuration steps include:
•
Entering switch parameters.
•
Creating zone groups (switch-port based or drive-bay based).
•
Assigning zone groups to servers.
The switch is configured using the Virtual SAS Manager (VSM)
application. For more information on zoning and configuration tasks,
see the HP Virtual SAS Manager user guide, available on the 3Gb SAS
BL Switch manuals page http://www.hp.com/support/manuals.
Returning the failed component
Follow instructions shipped with the replacement part.
Additional information
HP BladeSystem:
http://www.hp.com/go/bladesystem
HP storage:
http://www.hp.com/storage
HP support:
http://www.hp.com/support
HP manuals:
http://www.hp.com/support/manuals
Page 4
Advertisement
