Nothing appears on the external monitor.
■
Make sure the VGA computer cable is connected to your
computer's video port and the projector's
Make sure the cable from your monitor is connected to the
■
projector's
Monitor Out
You see a blue screen with the message
Make sure the cables are connected correctly, as described in
■
Chapter 1.
■
Make sure the power to your computer or video source is
turned on.
■
If you've connected a computer and one or more video sources,
you may need to press the
projector or the remote control to select the correct source. Allow
a few seconds for the projector to sync up after pressing the
button.
If you've connected a laptop computer, make sure it's set to
■
display on an external monitor. See page 36.
The message
Not Supported
Make sure your computer's resolution doesn't exceed UXGA and
■
the frequency is supported by the projector. See page 93. If
necessary, change your computer's resolution setting as described
on page 82.
Make sure the correct
■
menu. See page 56. It should normally be set to
The buttons on the projector don't work.
The Operation Lock may be enabled. Press and hold the
on the projector for 7 seconds to release the lock.
Computer1
port.
No Signal
button on the
Source Search
is displayed.
is selected in the Signal
Video Signal
port.
displayed.
.
Auto
button
Enter
Solving Problems
81