On Timer - Sharp 14D2-SS Operation Manual

Timers (continued)

ON Timer:

Automatically turns power on after the set length of time has passed.
$
1 2
4 5
7 8
0
@
CH
CH
FUNCTION TIMER
!,#
SYSTEM NORMAL
TV
(TV set)
POWER indicator (Flashing)
• To cancel the On Timer, press the NORMAL button during the On Timer mode.
• The minute setting of the timer is in 10-minute units.
• Always use the STANDBY/ON (ø) button on the remote control to turn off the power. The On Timer setting is
cancelled if power is turned off using the
• The Off Timer is automatically set to turn the TV set off in 2 hours, if the TV set is turned on by the On Timer. To
cancel the Off Timer, press the NORMAL button during the Off Timer mode.
• The picture which appears on the screen, having been turned ON by the On Timer, is set at the channel and
volume prior to Standby mode.
• If approximately 6 seconds pass without a button being pressed, the mode setting is automatically terminated
and the TV set returns to normal mode.
‰ 15
H Setting the On Timer
! Press the TIMER button 3
TV/VIDEO
times and the ON
appears.
3
6
9
@ Press the VOLUME UP ( ) or
DOWN ( ) button to set the
time. (Maximum time that can
be preset is 12 hours and 50
PICTURE minutes.) In this state, the
Timer starts to count down.
# When you have finished setting
the time, press the TIMER
button. The on-screen display
will disappear and the Timer
function is turned on.
$ Press the STANDBY/ON (ø)
button to put the TV set into
Standby mode. (POWER
indicator will flash to indicate
On Timer is set.)
When the preset length of time
(in the above example, 9 hours
and 20 minutes) has passed,
the power turns on and a
picture appears on the screen.
POWER switch on the TV set.
display
39
PAL
B/G