Sharp QT-CD110H Operation Manual page 10

<P=003>
(Continued)
E
CD playback
1
Set the FUNCTION switch to CD.
2
Press the CD EJECT button to open the CD
compartment.
3
Place a compact disc on the spindle, label side
up.
8 cm (3") discs may be played without an adap-
tor.
4
Close the CD compartment by firmly pushing the
corner marked "PUSH CLOSE".
The total number of tracks will be displayed.
5
Press the PLAY/REPEAT button to start play-
0
back from track 1.
" " will appear and playback will begin from
track 1.
To stop playback:
Press the STOP button.
Note:
When the CD operation indicator is lit, the power
is connected.
If you will not be using the CD player, set the
FUNCTION switch to STAND-BY.
APSS (Auto Program Search System)
APSS automatically locates the beginning of any
track.
To listen again to the track being played:
Press the DOWN button for less than 0.5 seconds
during playback.
To move to the beginning of the next track:
Press the UP button for less than 0.5 seconds during
playback.
To skip a number of tracks at one time, press the
UP or DOWN button repeatedly until the desired
track number is shown.
To start playback from a desired track, press the
UP or DOWN button whilst in the stop mode to
select the track number, and then press the
PLAY/REPEAT button.
Repeat play
An entire disc can be continuously repeated.
To repeat all of the tracks on the disc:
Press the PLAY/REPEAT button twice during play-
R
back.
" " will appear.
To cancel repeat play:
Press the PLAY/REPEAT button again.
The "
Cue and review
1
Load a disc and begin playback.
2
Hold down the CUE
forward, and hold down the
for audible fast reverse.
3
Normal playback will resume when the
VIEW or CUE
Notes:
If the end of the disc is reached whilst cueing, CD
operation is paused. Press the
button for fast reverse or press the STOP button
to stop CD operation.
If the beginning of the track is reached whilst
reviewing, the mode will automatically switch to
normal playback at that point.
Precautions:
Do not open the CD compartment whilst the
disc is rotating.
If the disc is damaged, dirty, or loaded upside
down, the total number of tracks will not ap-
pear.
Clean, replace, or reload the disc properly.
Keep foreign objects out of the CD compart-
ment.
Subjecting the unit to shock or vibration may
cause mistracking.
Keep the CD compartment closed except
when loading discs.
Playing certain compact discs at a high vol-
ume may cause mistracking. In this case,
listen at a lower volume.
The temperature range for playing compact
discs is recommended to be 5˚C (41˚F) - 35˚C
(95˚F).
If TV or radio interference occurs during CD
operation, move the unit away from the TV or
radio.
E-3
QT-CD111H/110H(SEEG) TINSZ0001SJZZ
R
" indicator will go out.
2
3
button for audible fast
REVIEW button
2
button is released.
3
3
RE-
REVIEW