Sharp MD-MT190H Operation Manual page 39

Stamping titles from another MiniDisc
Before stamping
When there are 2 MiniDiscs on which the same tracks
are recorded, you can transfer the character information
(disc and track names) of the Master MiniDisc to another
MiniDisc (for stamping).
1. What is a master MiniDisc?
A recordable MiniDisc that contains tracks and character
information. (You cannot transfer the information from a
playback-only MiniDisc.)
2. What is a MiniDisc for stamping?
A MiniDisc that contains the same tracks in the same or-
der as the master MiniDisc. (Make sure that the total
number of tracks of the master MiniDisc and the one for
stamping are the same.)
Master MiniDisc operation
1
Insert a master MiniDisc.
Do not mistake the master MiniDisc for the target one.
2
Whilst in the stop mode, press the MENU/CHRG but-
ton repeatedly to select "EDIT".
3
Press the ENTER/SYNC button.
4
Press the MENU/CHRG button repeatedly to select
"NAME STAMP".
5
Press the ENTER/SYNC button.
To cancel the operation, press the :OFF/HOLD button.
6
Press the ENTER/SYNC button.
7
When the unit displays "CHANGE MD", remove the
master MiniDisc.
Remove it without turning off the power. Or, the operation
will be cancelled.
Operation of the MiniDisc for stamping
8
Load a MiniDisc for stamping.
9
Press the ENTER/SYNC button.
The unit will finish recording the character information
and enter the stop mode.
Note:
If the total number of tracks on the master MiniDisc does
not match that on the MiniDisc for stamping, the unit will
display "Can'tSTAMP" and turn off the power.
If this happens, adjust the total number of tracks on the
newly recorded MiniDisc using the edit operation.
01/10/29 MD-MT190H(SEEG)_5.fm
MD-MT190H
ENGLISH
E-32