Using The Remote Control - Epson PowerLite 5350 Manual

Using the Remote Control

The remote control uses a line-of-sight infrared signal. To use
the remote control, point it towards one of the infrared
receivers located at the front and back of the projector. You
can use the remote control up to about 32.8 feet (10 meters)
from the projector. (This distance may be shorter if the remote
control batteries are low.) You must also be within a
angle from the front or rear receiver.
Note: The projector may not respond to remote control commands
in these conditions: ambient light is too bright; a certain type of
fluorescent light is present; a strong light source (such as direct
sunlight) shines into the infrared receiver; or other equipment
emitting infrared energy is present (such as a radiant room
heater). Correct these conditions to use the remote control or
control the projector from a computer.
Front
Freeze
A/V Mute
Freeze
E-Zoom A/V Mute
E-Zoom
Special effects
buttons (1-5)
Enter (pointer)
button
illumination
Esc button
battery cover
IR output
Power
Power
R/C ON remote control
OFF
On/Off
3
Enter
Esc
Back
cover lock
EPSON PowerLite 5350/7250/7350 Projector
Open the cover just below the
remote control commands.
30
Menu
Comp1
S-Video
Auto
P in P
8/99 EPSON
button to access additional
Esc
Power
Freeze
A/V Mute
R/C ON
E-Zoom
OFF
3
Enter
Esc
Help
Menu Help
BNC
Comp1 BNC
Video
S-Video Video
Auto Resize
Resize
P in P Preset
- Volume +
Preset
Volume
PowerLite 5350/7250/7350 Projector - 5