Table of Contents
Advertisement
4. Turn the video equipment on and start playback
5. Select the INPUT mode
Select the "INPUT 3" using the INPUT button on the projector or D INPUT 3 on the remote
control.
• When pressing the INPUT button on the projector, input mode switches in the following
INPUT1
order:
• When using the remote control, press the CINPUT 1/CINPUT 2/DINPUT 3/EINPUT
4 button to switch the INPUT mode.
6. Adjust the focus, image size, and projector angle
1. Adjust the focus by
turning the focus ring.
Focus ring
7. Correct trapezoidal distortion
Correcting trapezoidal distortion using the Keystone Correction.
On the projector
On the remote control
8. Turn the Power off
Press the STANDBY/ON button on the projector or the STANDBY button on the remote control,
and then press the button again while the confirmation message is displayed, to put the projector
into standby mode.
On the
projector
• Unplug the power cord from the AC outlet after the cooling fan stops.
On the
On the remote
projector
control
INPUT2
INPUT3
INPUT4
2. Adjust the projection
image size by turning
the zoom ring.
Shrinks
upper side.
On the remote
control
On-screen display
INPUT 3
S
3. Adjust the projector
angle using the HEIGHT
ADJUST lever.
Zoom ring
On-screen Display
_P. 30
_PP. 30, 31
Shrinks
lower side.
_P. 33
_P. 29
17
Advertisement
Table of Contents
Troubleshooting
