Adjusting The Image Angle - Epson PowerLite 30c User Manual

Adjusting the Image Angle

The projector should be set up so it is as perpendicular to the screen as possible.
Seen from the side
9.6
1
If it is not possible to set up the projector so it is perpendicular to the screen, it can be set up at a slight
vertical angle instead. You can extend or retract the front adjustable feet to adjust the projection angle within
a maximum range of 10º.
Procedure
Foot adjust buttons
(side)
•
When the feet are adjusted, it may cause distortion in the projected image. Use the keystone
correction function to adjust this distortion. (p.14)
•
If the projector is tilted horizontally, turn the bases of the front adjustable feet to adjust the angle.
Front adjustable
foot
Seen from above
Extend Retract
While pressing the two foot adjust
buttons at either side, lift up the front of
the projector so that the front
adjustable feet can extend.
Extend the front adjustable feet until the desired
angle is obtained, and then release the foot adjust
buttons.
To retract the front adjustable feet, gently push
down on the projector while pressing the two foot
adjust buttons.
13