Table of Contents
Advertisement
Projecting Images
Turning the power on and projecting images
Before using the
projector, make sure you
remove the protective
pad attached to the lens.
If there is a problem with projection even though the projector is set up and connected correctly,
refer to
p.15, 35.
TIP
14
Turning the power on and projecting
ON
images
If you set the "Direct Power On" to "On", the power of the unit will turn ON when
the main power switch is turned ON, without having to press the power button of
the remote control or the projector's control panel.
The projector is equipped with a "Child Lock" function that prevents young
children from accidentally turning the power on and looking into the lens, and
also an "Operation Lock" function that prevents mis-operations.
When using above an altitude of about 1500 m, make sure you set the "High
Altitude Mode" to "On".
This projector is equipped with an automatic
adjustment function that automatically optimizes it
when a computer input signal is switched.
If a laptop computer or a computer with a LCD
screen has been connected to the projector, you
may need to use keyboard or function settings to
change the output destination. While holding down
the
key, press
as
/
on it). After the selection is made,
projection will soon start.
Computer documentation
Remote Control
p.32
(the key with a symbol such
Control Panel
p.31
Example of output selection
NEC
Panasonic
SOTEC
HP
Toshiba
IBM
SONY
DELL
Fujitsu
Set mirror setting or
display detection.
Macintosh
Depending on OS, you can
change the output
selection by pressing
.
Advertisement
Chapters
Table of Contents
