HP StorageWorks 8B - FC Entry Switch User Manual page 17

Using Web Tools for ISL Trunking
Use Web Tools to view and modify ISL Trunking options through the Trunk Information Tab and
the Port Settings Tab on the Switch Administration interface. For information on how to install and
use Web Tools for the ISL Trunking feature, refer to the Web Tools User's Guide.
Use the Web Tools Trunk Information tab to view a summary of trunk groups and associated master
and member ports. Table 3-2 describes the headings displayed from the Trunk Information tab.
Table 3-2
Trunk Information Tab
Trunk Group
Master Port
Member Ports
The following table describes the headings and the tasks you can perform using the Web Tools Port
Setting tab.
Table 3-3
Port Setting Tab Features
Port Number
Trunking Enable:Disable
Port Enable:Disable
Port Speed
Note:
Brocade Trunking User's Guide
Trunk Information Tab Description
Port Setting Tab Features
ISL Trunking ports always must operate at 2Gb/Sec, setting the speed to 1Gb/Sec prevents
a port from participating in a trunk.
Using ISL Trunking
Description
A numerical number is displayed.
The associated master port for the group is
displayed.
Shows the member ports associated with the
group, separated by a comma.
Description
Each port is assigned a number. The port
numbers are displayed under this heading.
This allows you to enable or disable ISL
Trunking on a per port basis.
Use this to enable or disable a port.
Use this to set the speed of the port to 2Gb/Sec.
3
3-3