When The Indicators Provide No Help - Epson EMP-TS10 User Manual

When the Indicators Provide No Help

If any of the following problems occur and the indicators do not offer a solution, refer to the pages given for each
problem.
No images appear
Poor image quality
Only part of the image is displayed
(Large/small)
The image colors are not right
Is the lens cover still attached?
Is the power cord disconnected?
Was the power turned off and then straight
back on again?
While the indicator is flashing orange (during cool-
down ), the [Power] button on either the remote
control or the projector's control panel will not operate.
Have you pressed the [Power] button on
either the remote control or the projector's
control panel?
Is sleep mode active?
When sleep mode has been set to ON, the lamp turns
off automatically if no operations are carried out for 30
minutes while no video signal is being input.
The indicator lights orange at this time.
Has the image brightness been adjusted
correctly?
Is A/V Mute mode active?
Is the projected image completely black?
Some input images, such as screen savers, may be
completely black.
Is an image signal being input?
If No-Signal Msg. in the Setting menu has been set to
OFF, no messages will be displayed.
Try resetting all of the current settings.
p.39, 40
p.40
p.41
p.42
Probable cause
Images appear dark
Images appear green
No sound can be heard
The remote control does not work p.44
The power does not turn off
Condition
No images appear (Nothing at all appears)
Remove the lens cover. (p.6)
Check the power cord connection at the power inlet of
the projector and at the wall outlet. (p.6)
Wait until cool-down has finished. You can then use the
[Power] button on either the remote control or the
projector's control panel. (p.9)
Press the [Power] button on either the remote control or
the projector's control panel. (p.7)
Turn the projector power back on. To cancel the sleep
mode setting, set Sleep Mode in the Setting
environment setting menu to OFF.
Setting - Sleep Mode (p.24)
Adjust using the Brightness environment setting menu.
Video - Brightness (p.21, 22)
Press the [A/V Mute] button on either the remote
control or the projector's control panel to cancel the
A/V Mute mode.
(p.30)
Cancel the screen saver, or re-check the images being
input.
Change the No-Signal Msg. setting to Black or Blue for
messages to be displayed.
Setting - No-Signal Msg. (p.24)
If a message is displayed, refer to the item indicated.
Reset All - Execute (p.27)
p.42
p.43
p.43
p.44
Remedy
39