Valve Replacement - Regency U32E-NG5 Owners & Installation Manual

VALVE REPLACEMENT

1) Shut off the gas supply.
2) Remove the louvers (and bay door if installed).
3) Open the fl ush door and remove the door.
4) Remove the logs and brick panels.
5) Remove the grate by loosening the two screws and sliding the grate
out.
6) Remove the burner assembly by removing the 2 screws and lifting
it out.
7) Remove the 2 screws holding the Air Intake Hood to the rear fi rebox
wall and lift out.
8) Disconnect the inlet gas line.
9) Disconnect the EV1, EV2, and ground wires from the valve - as shown
below.
Ground
EV2
U32E-5 FPI Direct Vent Gas Insert
Grate screws
EV1
10) Remove the 11 screws securing the valve tray in place - then lift the
entire assembly out.
11) Push the valve assembly to the left and lift the entrire assembly out.
12) Replace with new valve tray assembly and reverse steps 10 - 1.
MAINTENANCE
37