Regency U32E-NG5 Owners & Installation Manual page 30

INSTALLATION
10) Install 4 - AA batteries into the receiver.
Ensure correct polarity.
11)
Plug receiver wire harness into the back of the receiver and
bundle wires with the wire clip - as shown below.
12)
Plug receiver wire harness wires from the receiver into the DFC
box.
30
13) Reinstall the DFC box onto the velcro pad on the fl oor of the unit.
14) Install the heat shield to the receiver with two screws and attach
15) Reverse steps 5 and 4.
16) Match the remote control to the receiver - see remote control
instructions.
17) Reverse steps 2 and 1.
18) Check to ensure there are no gas leaks..
Wire clip
to the fl oor of the unit with a velcro pad.
Heat shield
U32E-5 FPI Direct Vent Gas Insert